NO! The maximum power rating of some amplifiers can be five or ten TIMES the RMS, or continuous, power output the amp is capable of. This problem is far worse from low quality imported amplifiers than from more reputable higher quality ones. Always look for the CEA power rating on the box, if it is available. This is a government regulated program which ensures the consumer is aware of actual amplifier performance.
Yes, are we talking rms or max? If its rms you will have no problem. well the amp is a 1500 watt max but 350wx1 rms in 4 ohm
the subs rms tells you what u need.. so a 900 watt rms sub would be best with an amp from 800-1000 watts
Find out what the rms is for that sub woofer,if it'1000 then find out what the max is,then you could go between the rms power and the max power to get the right amount of watts.
since u have two I would say 400 or 500 rms apm
RMS is the max watts its recommended to run on, for example i got 2 15's that are 3000 watt rms so i got a 2500 watt amp. You don't want to get too big of an amp because it will put stress on the speakers and wont last long.
a 500 watt sub woofer puts out 250 RMS a 500 watt amp puts out the same and if you want a good setup get a sub with RMS and a amp with 1200 max so 600 RMS will be powering the same 500 RMS sub woofer then you can tune it to push the sub woofer a bit and the sub woofer should take it I recommend ether mono single channel 2 channel brands go name brand if u want support later or go no name to be different
1000W Kenwood KAC-7204 2/1
Any amp will power a 15" sub. What you need to know is what is the RMS of the 15" sub. Lets say its 200 watts RMS than you will want a max of 200 watts for your amp.
Yes. Peak power or max output is rubbish. You will never get clarity at a speaker or amp's max output. RMS is what it's all about.
It is advertised as a 5,000 watt max amplifier and it is capable of putting out 300 watts rms according to their owners manual but you will never see them advertise it anywhere and that is assuming you are using a 14.4 volt battery which I don't know anyone who has one.
I recommend Two subs with like 150 watt RMS so you aren't under powering the subs too much. Maybe some 10" JL's or something.
When buying an amp its best and safe to use the 1:1 ratio. That would mean if subs RMS was rated at 350 watts then get a 350 watt amp. Alot of installers will use 3:1 ratio because the subs max rated at 1200 watts so they say you will need a 1200 watt amp. But the truth is that sub may only peak a fraction of a millisecond. So unless your competing for a title championship there is no need to destroy you subs that you paid so much for.