1979 corvette hood releases but passenger side not releasong problem?
got same problem on one of my three vettes. no big deal. just needs adjusting after you get hood to open. first try to pull realease lever, if drivers side realeases, go to passenger side and firmly press down without re-locking mechanism and move hood towards drivers side or towards passenger side. need to shim hood latch and/or adjust hook underneath hood on the hood not the chasis. do it over and over til you get right. i know how to do it but never get around to it. good luck! it will work. also oil up all movable parts before closing after you get it open could be possible that the cable housing has pulled through on the left side mounting clamp too. will need to replace cable if this happens. cheap aftermarket cables are notorious for this.
For some reason your 1999 Corvette is blowing warm air on the drivers side and somewhat cool air on the passenger Any ideas?
I had the exact same problem twice in 3 years. I resolved it BOTH times by disconnecting the NEGATIVE side of the battery for approximately 5 minutes, then re-connecting it. The Corvette Rep told me to do so. It worked. Bad aircon unit, of a bad engine problem Bad aircon unit, or a bad engine problem Bad aircon unit, or a bad engine problem
Why won't my 1987 Corvette start after i have ran it but then when i let it cool down it would start?
Your 1976 Corvette wil not turn over sometimes its like there is no battery it seems like it does this after it gets warm not sure what to do please help you?
the car needs to be scanned for abs codes. for this you need a scanner tool some vettes have self diagnostics where you can retrieve codes with the cars info center check google self diagnostics 1991 chevy corvette. if there is a bad sensor or control module the light will just come back on until problem is fixed need code to track problem.
What does it mean when a Chevy Camaro transmission is rebuilt to Chevy Corvette specifications and how does that benefit you?
Does not make any sense. Sounds like a sales pitch to me. I had a Technician at the dealership do this for me on the side he said it has to do with changing a lot of the internals, springs, bands, clutches, steels, seals, gaskets etc. corvette parts are made with better performance material then camaros. I haven't had a problem since the "corvette spec" rebuild, been 4yrs. I recommend it.
it is located on the firewall directly behind the distributor, there are 2 realys there it is the one closest to the drivers side. the 2 relays are identical, if you think the fuel relay is the problem you can swap the wires to the relay next to it and the problem should be fixed, if not then its not a relay problem
Why does no ac air blow through the dash vents on your 1994 corvette Air only comes out via the floor or the windshield?
Check your Air Conditioning / Heater Vacuum Check Valve. It located under the passenger side fuel rail cover. This plastic part break apart because of the heat of the engine over time. The vacuum tubes probably are just hanging next to this valve. I had this same problem and this was the part in question.