first remove the air cleaner assembly. That would be 2 10mm bolts on the valve cover...then tilt the assembly up and disconnect the vacuum line attached to the underside. Then there are 4 12mm nuts on all 4 corners.....you can get these very easily with a 1/4" drive set. Then label and remove all the vacuum lines, remove the fuel line and unplug the choke. If the carb has been there since 84 you might need to pry a bit
Toyota tercel, Automotive Repair Manual, 1987 thru 1994. (Haynes)
in the engine
1.5L
The timing setting for a 1988 Toyota Tercel is the "3E" hole lines at the top. This setting is for a Tercel EZ 1500 engine.
The starter on a 1991 Toyota Tercel is located in the front of the engine. It will be located on the left side.
To set the carburetor on a Toyota E engine 1300, you must have the tools to open the bolts. Refer to the pictorial image from the manual to set the carburetor.
On the back of the engine block.
No
Look at the bottom end of the engine
The check engine light on a Toyota Tercel can come on for a variety of reasons. It can be come on whenever there is a problem with the engine that needs attention. To reset it, disconnect the battery for a few minutes then re-connect it.
yes, but not for long. The cylinder will get gas washed and score the cylinder walls as well as gas wash the rings. You will need an engine rebuild.
The fuel pump on a 1983 Toyota Tercel is located inside the fuel tank. It sucks fuel from the tank and pushed to the engine.