0
1988 Ford F150 with no heat 2 hoses at the firewall heater core one hose is hot one hose cold Engine hotter than normal Bad Heater core or bad thermostat Thanks?
Daodung
heater?AC fan does not go on? Temperature gage does not work.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How does a thermostat on a 2002 dodge ram go in does the spring side of the thermostat go toward the engine or does it go toward the hose thanks?
The spring goes towards the engine.
1997 Honda accord heaterdefroster only blows cool air Is this a thermostat problem or what Also where is exact location of thermostat on 4 cylinder engine Thanks William?
If the engine reaches operating temperature on the gauge, then your stat is working properly. If there is no gauge,take your hand and place it on the two hoses that go into the passenger compartment thru the firewall. Both of these heater hoses should be HOT to the touch. If both hoses are cold, replace your stat.( Follow the top radiator hose down to the water outlet; this is where your stat is). If one hose is hot, and the other is much cooler, this indicates a plugged heater core which needs flushing or possibly replacement. I you. Mark
How do you replace a thermostat and add coolant to a 1998 Dodge Intrepid?
According to Advanced Auto Parts the Thermostat is located on the lower radiator hose at the engine. Thanks, Kit
Why would a 1995 Ford 3.0 engine run so cool and not create heat for the heater and not build pressure?
Open the radiator cap, rev the engine and at the same time check to see if the radiator is flowing. if so, thermostat is probably stuck open. I'm having the same problem. I boiled the thermostat and it worked as it should at the proper temps. Could the water pump impeller be loose from the shaft? My car doesn't run hot, but I just bought it and have only ran the engine at temps below freezing. Could an air intake door to the heater be stuck open? Thanks.
You have replaced the water pump thermostat and bled the system on your 2000 Chevy venture it still blows cold to luke warm air any ideas thanks?
The heater core is plugged. Blow it out with a compressor. If that does not work replace the heater core.
How do you change the heater core on a 1978 Chevy Nova 305V8 and where is it located on the car?
How do you change the heater core on a 1978 Chevy Nova Custom with a 305 v8 engine and where is it located on the car? thanks jj
In your 90 silverado 350 it only blows cool-warm air on high heat maybe the thermostat electronic switch ist opening a valve or a duct door need help thanks?
If your engine warms up, but you don't get heat from your heater, check your coolant level, if it's low, this would be one explanation
Where is the thermostat on a 99 Dodge Intrepid with a 2.7L engine?
It is located on the lower part of the engine and requires a special tool, $50, to remove the hose clamps unless they have been changed already from the OEM clamps. You will need a lift to accomplish the job and several hours. Good luck. It is on the engine at the upper radiator hose. When reinstalling the thermostat make sure the spring is towards the engine. I didn't find it there According to Advanced Auto Parts the Thermostat is located on the lower radiator hose at the engine on a 1998 2.7L Intrepid. Thanks, Kit
Where is the thermostat located on a GMC Safari 1998 Thanks?
fallow your top rad hose were it meets on the top of the engine it under the housing were the rad hose clamps to drive safe
How do you remove heater control panel for Renault laguna?
how do you heater control for renault laguna 1999 thanks
Where is the ain fuel line under neath the hood on a 1988 Toyota 4x4 pick up truck with the 2.4 engine thanks?
It comes op the firewall right in front of the passenger. It is a steel line, once it clears the firewall it turns to a rubber fuel line via a hose clamp.
How do you determine if the heater blower switch or heater blower motor is bad on a ford 2002 crown Victoria?
You can unplug the blower motor and run a jumper wire to test the blower motor. If it is grounded through the plug you'll have to run a ground wire to it also. Blower Motor tested good. The Problem was the Blower Motor Controller which was located on the firewall just below the Heater Hoses. Thanks for responses to question.
