answersLogoWhite

0

  • Electric Windows
  • Headlights Tail and Brake Lights
  • Ford Explorer Sport
  • Ford Explorer XLS

1990 300ZX non turbo lights warning lamp comes on when pressing on brake pedal but all brake lights work fine anyone know why?

User Avatar

Wiki User

βˆ™ 2009-08-18 18:26:40

Best Answer
Copy

It didn't work for me but check for corrosion on the third break light bulbs connections. check fluid level in resevoir. <><><><><><><><><> I had a similar problem. I found a broken connection on the circuit board in the stop and tail light sensor, located on left side rear cargo area.

2009-08-18 18:26:40
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Why do most of your warning lights fade in and out while the engine is running on your 86 300zx non- turbo?

It is an over charging votlage regulator in the alt. Rare problem.


What does the HICAS warning light mean on your Nissan 300zx twin turbo?

four wheel steering warning light


Anyone have the intake torque specs for a 90 300zx non turbo?

look up 300zx manual on net it has all specs.


How do you remove the complete headlight on a 90 300zx?

A 1990 300zx headlight is recessed into the bumper. To remove it, first loosen the headlight bracket bolts. Unplug the lights and push the housing outward. Be careful not to ruin the weather stripping for the lights.


What runs all lights on a nissan 300zx?

The alternator when the engine is on, and the battery when the engine is off.


300zx running lights work but the brake lights wont?

Check bulbs they are double filamented smaller for brake lights larger for tailights Check the fuse Check the operation of the stoplight switch


Where is relay for the lights located on a 1986 Nissan 300ZX?

UNDER THE HOOD IN THE FUSE BOX 2 FOR EACH LIGHT


How do you fix the dashboard lights on a 1987 Nissan 300ZX?

Until you say what is wrong, I recommend using a sledge hammer.


Brake lights constantly on 1984 300zx?

More than likely the brake light switch is defective or out of adjustment.


Why would parking lights stay on even after they've been turned off on a 1990 Nissan 300zx Front marker lights stay on as well.?

faulty hdlmp switch


Why does your warning light for cooling system stay on on your 1984 Nissan 300zx?

You are low on coolant or the low coolant sensor/wiring/connection is bad.


Did Anyone had trouble with peeling clear coat on a 1993 300zx?

yes, only on the driver's side t-top


Where is the mass air sensor 300zx?

On the 89- 300zx the mass air flow sensor is located under the panel that is between the head lights. remove the panel and you will find the air filter box. the maf is bolted directly to the filter box


How do you repair dashboard lights on a 1990 Nissan 300ZX?

It depends what lights you are talking about, most dash lights are just bulbs. However in the cluster for digital lights and the fog light acessories they are done by LED lights in which you can replace if you know the right voltage. There are a lot of dash lights, so IRepairing Dashboard LightsTake apart the dash (or area where the lights are burned out) and replace the bad bulbs with good ones.


How do you turn the fog lights on in a Nissan 300zx?

press on the button under the cruse control that are on the control pod- while you have your low or high beams on.


How do you change the fog light bulbs on a 1987 Nissan 300zx?

This can be done 2 ways: 1 remove the turn signal lights and remove the 3 screws holding on the lights or 2 jack up the car and remove the 3 screws from the bottom, these are at the back of the lights.


Is the 1986 Nissan 300zx a z31 or z32?

300zx from 84 - 88 are z31


Where is the fuse for a 300ZX foglights where is the fuse for a 300ZX windows?

The fuse box is located on the drivers side lower kick box. &Ecirc;The fog lights are located in the first column, a 15A fuse, &Ecirc;and the windows are located in the middle column and require a 20A fuse..


How do you access fog lights in a 1990 Nissan 300zx?

Unscrew side marker /signal lights and there will be three bolts inside behind the fog light. Unsnap the plug connected before unscrewing and pulling the fog lamp out.


How can you fix your 1990 300zx when you turn the lights on only the HI beams workwith no tail lights on but when you step on the brake the LOW beams go on tail lights go off and the dash lights spedo?

your light wires have been crossed somewhere ( probably at the tail lights, brake light circuit crossed with marker lights ) look for recent wiring work on the lights and make sure the proper wires match up.


What would cause a fuse to blow when you turn the lights on your 1988 300zx?

A short circuit. Look through your connections to your 'lights' and make sure there are no short circuits. If you want to know about short circuits see related links below.


Tail lights and inside dash light both went out on an 84 300zx?

check your fuseable links in your engine cpt. black controls those things


What does the lights sensor in the dash mean in a Nissan 300zx 1986?

That light indicates that the headlight switch is in the on position with the engine not running and the drivers side door open.


Why would the high beams work but not low beams and break and tail lights only work if instrument panel lights work 1986 300zx have checked bulbs and fuses replaced switch behind brake pedal?

headlight switch


Shift lock blows fuse on 300zx?

A shorted wire in the console or the brake circuit. Does the car still have brake lights? If there are no children in your household then it is possible to defeat the lockmechanically.