answersLogoWhite

0


Best Answer

A long shot: If your catalytic converter is failing, there can be a blockage in your exhaust that then increases blow-by past your rings in the engine, resulting in pressure building in your crankcase that forces oil (actually air saturated with oil) past your PCV valve. Had this happen years ago, and had oil in the air cleaner chamber of a Suzuki Samurai. Catalytic converter got worse, pressure increased to the point it would actually blow off the PCV hoses. Also had intermittent loss of power in the engine. Basically the guts of the catalytic converter were bouncing around and occasionally blocking the exit, causing the backup. Unfortunately the shop I took the car to for a diagnosis mis-diagnosed the situation and said I needed a new engine...I put in a new engine and still had the trouble! How to tell if maybe the catalytic converter is going bad? Hit it witl a mallet. If the element inside is loose you will hear it rattle around. Good luck!

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1990 accord ex. i have oil in my airintake. replaced pcv valve it didnt help. whats wrong with my car?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How often does the idle air control valve need to be replaced on a Honda Accord 1999?

Only when it fails.


What is the valve clearance on 1992 Honda Accord?

"What is the valve clearance on 1992 Honda accord?"


Where is the PCV valve located on the VW new beetle?

the positive cranckcase ventilation (PCV) is located at the very top of the ENG + airintake. look for "y: hose. Christian


Where is the PCV valve on an 1988 Honda Accord picture?

valve cover


What does a PCV valve do in a 2005 Honda Accord?

What do a pc vale do in a Honda Accord


Where is the PVC valve on a 2001 I4 Honda Accord and when should it be replaced?

on top of the valve cover(rear)center attached to the little rubber hose. replace around every 40k mi. for better gas and better idle.


Where is the expansion valve on a 98 Honda Accord?

The expansion valve, on your 1998 Honda Accord, is located just before the thermostat housing. You can follow the water hose from the radiator to the expansion valve.


Where is the VTEC solenoid valve located on 02 Honda Accord EX?

Where is the location of my vent valve solenoid 98 honda accord ex v6


2003 Honda Accord 2.4l 4-cylinder valve adjustment?

Local shop told me that there's no need to do valve adjustment on 2003 Accord.


What causes high NOx on a 96 Honda Accord?

Check your EGR valve. I have a 95 Accord and failed with High NOx, double the limit. I replaced the EGR valve and cleaned the EGR ports on the intake, they are under the fuel rail. I passed on the second attempt. The ERG valve was 140.00. It took a few hours to scrape the carbon off the clogged ports, some carb cleaner helps.


How do you replace the expansion valve 1992 Honda accord ex?

how do you replace the expansion valve


Do you adj valve lash ON A 2003 HONDA ACCORD 4CY?

To do a valve lash on a 2003 Honda Accord make sure a lash gauge is on hand. Valves lashes adjust the valve to piston clearance on cars. Be sure to use the appropriate specifications of clearance for the 2003 Accord.