Honda cars are designed to do this. When the engine is warm the fan will run up to 15 min. after turning the engine off.
Are you just trying to start the engine, or is it already running? If it is running it sounds like the power steering pump is bad.
The H22 is a high-performance engine that debuted in 1993 as an engine for the Honda Prelude VTEC. This was a signature engine worldwide until the end of production for the prelude in 2001.
After running for a few minutes...Need more information?
The 1986 Honda prelude 2.0 Si has a A20a3.
A 1994 Honda Prelude S would not have a VTEC engine in it (assuming it has the original engine in it). It should have the F22A1 in it which is SOHC and Non-VTEC.
Yes, however the procedure will involve a lot of customization.
Considering there were five generations of the Honda Prelude, this question needs to be more specific. The Prelude lineup featured a variety of engines over the years of different engine families, ranging from 1.8L to 2.3L The fifth generation Prelude (1997-2001) featured a 2.2L DOHC VTEC engine rated for appr. 195-200bhp. The fourth generation Prelude (1992-1996) featured two different engine families, the "H" engine and the "F" engine. The "H" engine in the 4th gen is a DOHC design, the 2.2L variant having VTEC, featured in the VTEC trim and being rated for 180bhp-190bhp at the end of the generation. The 2.3L "H" engine was DOHC but did not feature VTEC, was found in the SI trim, and rated for 160bhp. Finally, the basic level trim featured the 2.2L SOHC "F" engine, which also did not include VTEC. The "F" engine in the 4th gen Prelude is rated for 125hp. If you want more information on the older Prelude, or Prelude engine options outside of the USDM, check wikipedia as the Prelude article is maintained by dedicated Prelude enthusiasts.
Provided they both share an h22a or f22a engine they should be a perfect match!
No, check it after the engine has not been running for at least 15 minutes.
You could, but because the '94 Prelude is heavier than the '89 Prelude, it doesn't make sense to swap in a smaller powered motor.
2 to3 minutes
yupps