0
1993 Chevy Corsica 3.1 engine radiator fan don't work what to do?
Wiki User
∙ 16y ago
Try wireing it straight to the battery and see if it turns on. If it dont turn on then your motor for your fans is bad and needs to be replaced.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the oil filter on a 1993 3.1 v6 Chevy Corsica?
It is screwed onto the engine near the bottom on the LH side. The LH side of the engine is the side near the radiator.
Location of ignition module for 1993 Chevy Corsica?
The ignition modual is in the front of the engine compartment, below the front manafold between the motor and the radiator above the starter
How fast can a 1993 Chevy Corsica go before the governor kicks in?
A 1993 Chevy Corsica can only reach 111 MPH before the factory governor will be applied....this is with the 2.2 Liter engine
Did not find trunk release button on 1993 Chevy Corsica?
where is the trunk release button for 1993 chevy corsica
Will a transmission from a 1993 Chevy Corsica fit a 1996 Chevy Corsica?
Ask the same question at batauto.com in the forum for transmissions. Koug
How do you remove headrest from 1993 Chevrolet Corsica?
how to remove headrest of 95 chevy corsica without tabs
Where is the temp sensor that turns the radiator fan on located on a 1993 Chevy Corsica with a 3.1 engine?
the temp sensor is on the thermostadt but it doesnt control the rad fan. you're thinking about the rad fan switch which is in one of the fenders by the firewall or right on the rad support.
Where is the fuel pump relay switch on a 1993 Chevy Corsica?
in the trunk
Where is the sensor for the oil and temperature gauges on a 1993 Chevy corsica?
where are the senders on a 1993 Chevy corica for the oil and temputer gages to reinstall
Where is a thermostat located on a 1993 Chevy C1500?
Should be in a removable housing at the engine end of the upper radiator hose
I can't find the radiator cap on my 1993 Corsica does it have one?
It's the overflow tank cap.
How do you replace the front strut motor mount on a 1993 Chevy Corsica 3.1 engine?
It is as simple as removong 2 bolts and replacing the mount. Goodluck, JOe
