0
check the wires that run through the door inside the rubber boot they tend to crack and break if so just solder in a piece of wire done deal...............hey i just had this prob. i had to change the ignition switch but i also had no instrument lights or turn signals.was told all or some of these can go either way i changed the switch and it works again! good luck , wolf
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
When was Jeep Grand Cherokee created?
Jeep Grand Cherokee was created in 1993.
Will a 1993 Jeep Grand Cherokee transmission fit on a 1993 Jeep Grand Cherokee Limited?
If same engine and transmission models, yes.
What is the towing capacity of a 1993 Jeep Grand Cherokee 4WD 5.2 Engine?
The 1993 Jeep Grand Cherokee 4x4 tow rating is 5000 lbs.
Will a 1997 4.0 jeep trans fit in a 1993 4.0 jeep?
If they are Cherokee's then yes. Grand Cherokee no.
How do you replace 1990 Jeep Grand Cherokee knock sensor 6 cylinder?
The Jeep Grand Cherokee didn't exist until 1993.
What years of Jeep Grand Cherokee transmission interchange with a 1992?
None, there wasn't a Grand Cherokee until 1993None, there wasn't a Grand Cherokee until 1993
Will the door on a 92 Jeep Grand Cherokee fit on a 96 grand Cherokee?
The Grand Cherokee did not exist until the 1993 model year.
Would a 1993 Jeep Cherokee wheel fit a 1996 Grand Cherokee?
YES....
Where is a fuel pump on a 1993 grand Jeep Cherokee?
It is in the fuel tank.
Where is the amplifier for a 1993 Jeep Grand Cherokee?
under the rear seat
Where is a 1993 Jeep Grand Cherokee drivers door?
Look on the left side of a 93 Grand Cherokee. It will be the front one.
Does a 1993 jeep grand Cherokee have grease fittings on the wheel bearings?
No, the front hubs are sealed units on a Grand Cherokee.
