0
1993 gand am if the crank sensor breaks can it just be pushed through to the oil pan?
Wiki User
∙ 15y ago
no... if it can be shoved into the oil pan then the front cover is broken and must be replaced... if the crank sensor is broken or malfunctining the vehicle will not run
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the CPS on a 1996 Jeep Grand Cherokee?
Crank sensor goes through the top driver side of the bell housing. Cam sensor is inside the distributor.Crank sensor goes through the top driver side of the bell housing. Cam sensor is inside the distributor.
Can the Kia Sorento crankshaft pulley bolt damage the crank sensor?
Others have had problems with the crankshaft pulley bolt on their Kia Sorento damaging the crank sensor. This can happen if the bolt breaks. The timing belt can be damaged as well.
Where is the crankcase sensor located on a 2003 pt cruiser turbo?
It does not have a crank case sensor.It does not have a crank case sensor.
How do you adjust 1994 3.8 Chrysler Town and Country crank sensor?
The on l y adjustment on the crank sensor is accomplished by gluing a specific thickness spacer to the tip before installation. The spacer is pushed against the flex plate as the bolt is tightened. The spacer is available from the dealer.
What is a crank sensor for a 1995 blazer?
A 1995 blazer does not have a crank sensor. SORRY
Where is crank sensor on 1991 firebird 3.1L?
3.1L dont have a crank sensor
Where is the crank sensor located on 1989 camaro rs?
That year did not have a crank sensor.
Does a1998 Jeep Wrangler crank sensor have a fuse?
No, there is no fuse for the crank sensor
How do you avoid crank sensor on 1997 Honda Accord?
Avoid the crank sensor?
Is there a crank sensor on a 93 suburban?
NO. A crank sensor are cam sensor was not introduced until the year 1996.
Do you need to replace cam sensor after replacing the crank sensor?
if you have a code w/ cam to crank reference then yes. if only a crank sensor issue the no
What is the location of the crank position sensor on a 1990 Firebird 3.1?
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
