Did you change the bulb in the rear? Yes. The hazzard lights use the same bulbs in the rear as the turn signals. They work with the hazzards on but not with the turn signal.
its either a fuse, or the turn signal switch needs to be replaced
it is the turn signal stalk. here is a good writup for repair. http://tss.likeabigdog.com/
It depends on the exact problem. If it's that both brake lights in the back do not work and the middle one works, it could be your turn signal switch.
In the 2000 Chevy Lumina it is on the driver's side of the dashboard, close to the windshield. It is a small hole. I would guess the design hadn't changed since '97, since it works so poorly in 2000, they obviously hadn't improved it any.
The 1991 > 1994 Chevy Lumina Speedometer, Odometer and maybe the RPM gauge gets a signal from the ECM computer. This ECM signal is feed to a module in the instrument panel, which feeds the three items above. If all three are not working replace the instrument panel or the module (which is inside the panel), but swap the odometer to keep your mileage correct for the vehicle. Note: The ECM gets its signal from a VSS on the Transmission and the ECM feed three areas in the car: Speed Control, Speedometer and one other (?). If the speed control works, the problem is not the VSS or the ECM. The problem is in the Instrument Panel.
You need to replace the turn signal flasher; turn on the left side and follow the clicking sound. Even though one side works, a faulty flasher can cause this problem.
Your radio signal works by using its signal to go to a tower and back to your radio (Via antenna).
You have an electrical fault
If you mean the fan works on high only it's the blower motor resistor.
Could be turn signal flasher
you need new light that is the most comen
If neither signal light works, the flasher may very likely be the problem. The hazard lights and the signal lights work off different flashers.
Corroded or worn socket Loose connection Bad turn signal flasher? Defective bulb?
Usually this a faulty signal light switch. The Signal light switch disconects the brake light on the signaling side and makes it flash.
you can't. you have to get a new one. Go to a local auto recycler. One for my car from the dealer was $300. I paid $30 for it from the auto recycler and it works great.
You have a clogged or possibly rusty fuel injection line....try using a bottle of fuel injector cleaner, it worked for my 93 lumina.
It's the turn signal switch at the steering wheel, that is the problem. Very exspensive to get replaced,and to hard for an amuture to do. If you have checked all fuses and bulbs sounds like ur turn signal switch in ur steering wheel. I had the same problem and was switch.
Assuming you have checked all of the bulbs, sockets and wiring, the signal flasher could be weak or the signal switch is bad.
This is an electronic device which converts electrical signal into a digital signal.
It's the turn signal switch which is the culprit.
Typically, a turn signal that works on one end of the car, but not the other, is just a burned bulb. It's when one whole side works and the other doesn't that things get a little more involved. Some European cars will alert the driver when a bulb burns out, and temporarily disable that circuit until the bulb is replaced and the key cycled on to off and back to on.
i have a 96 Monte Carlo and i had the same problem. try pulling the turn signal switch to you slightly while in the signal position. works for me every time.
my turn signal works but my switch will not return after i make a turn. please explain to me how to fix the problem