answersLogoWhite

0


Best Answer

The most common failure associated with those symptoms is the Crankshaft Position Sensor.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1996 Jeep Cherokee that turns over but will not start no spark to the distributor or the spark plugs replaced the ignition coil and the pick-up coil in the distributor Engine is getting fuel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1989 Mazda will not start it is getting fuel and has a good spark from the coil to the distributor cap but has a week spark at the plugs Have replaced ignition coil distributor pickup coil plug wires?

try to get a new ignition rotor


1996 Jeep Cherokee that turns over but will not start no spark to the distributor or the spark plugs replaced the ignition coil and the pick-up coil in the distributor Engine is getting fuel .?

There's also the crankshaft position sensor mounted on the drivers side / top of the transmission housing. Some auto parts stores carry them, some don't. The voltage connector is on top of the intake manifold, near the firewall. Also check the voltage to the ignition coil.


Jeep ignition 1990 Cherokee Pioneer when starts runs strong it takes from 1 crank to 100 times to start it it shuts off randomly I replaced ignition cylinder and ignition switch won't start why?

Check to see if you are getting spark (coil) and fuel


Why is a 1995 Riviera not getting a spark to the distributor?

a '95 riviera does not have a distributor. If you mean the ignition coils, then you probably looking at bad ignition module-located under the coils. Or bad crank sensor.


Why wont 1987 305 fire and why is it not getting gas to the injector's?

ignition control module in the distributor


1997 2.5 that has elect to the distributor but not getting any spark?

Check the ignition control module.


What does it mean if you are not getting fire to the spark plugs?

Your ignition module may be out. Or your distributor is out. What kind of vehicle?


Why if you replaced the cap and rotor spark plugs and wires ignition coil and ignition control module in the disributor do you still not get spark at the spark plugs?

== == check that you are getting power to the distributor. i am assuming you are talking about a earlier model vehicle Have you checked the ecm relay? maybe the pickup coil assy.


You replaced the coil and distributor and cap why are you not getting any spark?

electronic spark modulator bad.


Why would the ignition coil on a 1997 Mitsubishi Montero not be getting electricity?

whi ignition coil wont jabe electrisiti on mitsubichi pk up and distributor


99 cougar cranks but wont start replaced distributor crankshaft sensor spark plugs smell like gas but not a blown head gasket I think its not getting fire to start any ideas?

try a new ignition coil


Why wouldn't a Chevy 350 turn over replaced the battery and alternator fuel pressure gauge reads 4 - 5 psi when the fuel pump is on what's going on?

Is it getting spark?, if it isn't getting spark to the plugs and you have a HEI distributor the ignition control module could be blown, take cap off and replace the module, it's the thing with the wires plugged to it inside the distributor.