0
1996 Toyota Previa van chirping sound what could the cause be We just had the supercharger pulley replaced and the belts replace within the last month and now the chirping is more frequent and louder?
Wiki User
∙ 15y ago
Other possibilities could be one of the the accessory belt idler pulleys - either the one that connects to the accessory driveshaft bracket, or the one that connects to the A/C compressor bracket. If the bearing has gone bad, it would likely produce a chirping/squealing noise. Another thought is the accessory driveshaft coupling, which is a common problem in the Previa vehicles. It consists of two round, rubber pieces that act as a support/damper between the accessory driveshaft. The rubber eventually wears out and deteriorates, which will lead to noise and vibration. Another idea is the alternator ... have you checked that out to see if the chirping sound could be due to worn alternator bearings? Or if the belt tension is too tight, that could be putting more stress on the shaft and bearings, increasing the frequency/volume of noise. If you have a mechanic's stethoscope, it would come in handy for locating/diagnosing noises such as chirps, squeals, etc. Good luck!
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
You have lost your supercharger belt for your grand prix gtp 1997 que question is should you just replace the belt or do you need to replace the supercharger if you decide not to replace or fix the be?
You don't have to replace the supercharger you will just have no performence power and bad gas milage, but you will not harm the supercharger. Same thing happen to me, year later I replaced my supercharger belt and supercharger was fine.....dont wait get it fixed dont hurt the GTP!!!!!
On a 98 Chevrolet Malibu a chirping noise under the hood on the passenger side is caused from what?
I had the same chirping noise. My chriping was the belt and/or the power steering pump. I replaced both. no noise now. I would first replace the belt, then the pump
Supercharger oil for 2002 pontaic bonaville sse what is the best oil to replace it with?
supercharger oil for 2002 pontaic Bonneville ssi what is it and what is the best oil to replace it with?
Why is there a chirping noise coming from the alternator?
replace alternator belt
How do you replace the supercharger on a 1998 Pontiac grand prix?
no :(
I still have a chirping noise after replacing the belt. Is it recommended to replace the belt tensioner when you replace the belt on a 2003 Cadillac Deville with 70K miles?
Check all your accessories pulled by the belt. There are a lot of bearings in these accessories that can cause the " chirping noise".
1998 park avenue ultra has loud knocking coming from super charger what could it be?
It might be the supercharger going bad. The supercharger has a little coupler that is located in between the supercharger nose and the main body. This coupler is located inside and once it starts to wear out it will start making a clunk sound. You can replace the coupler, replace the nose, or rebuild the whole supercharger. Thank you, From www.SuperchargersOnline.com
What tools are needed to replace 1995 riviera supercharged battery?
The supercharger has no battery.
What causes Chirping on 2004 Toyota Sequoia front brakes. Is there a Solution?
Chirping means the brake pads are worn out. That is a warning device built into the brake pad. Replace the brake pads.
What is the past tense of replace?
The past tense of "replace" is "replaced."
If you remove the supercharger belt on a 3.8l GTP are you going to have poorer gas mileage I know you will lose power?
do not remove your supercharger belt, the engine is set up to work with supercharger. my belt broke on mine and i was told to replace it before i drive it to much
How to fix a supercharger with rattling in snout of supercharger is there a diagram?
If your supercharger is an Eaton type supercharger and it is making noise that is an early indication that the supercharger might need a rebuild. A lot of times the noise is actually coming from a little coupler that is located in the inside of the supercharger. This coupler has 6 holes in it and over time these rounded holes will wear out and become an oval shape. Once it becomes oval shape the supercharger will start to make a rattle sound. If left untreated the rattle will lead to the bearings going bad and then the seals. You will then need to get a complete rebuilt done on the supercharger. The coupler is easy to replace. You basically have to take the supercharger noise off with the 6 bolts that holds it and then once the two ends pull a part the coupler will be sitting right there. Just slide the coupler off of the pins and replace it. Then slide the two ends together and bolt it back up. You will also need to refill the supercharger with oil.
