Method 1: Simply remove the negative battery terminal, and hold the brake pedal in for at least 30 seconds. (NOTE: The SOLE purpose of holding the brake pedal in is to drain any residual power from the electrical system, allowing the computer to reset itself). Then, reattach the negative battery terminal.
Method 2: Remove your center console (the trim piece around the shift knob). The ECU is located directly underneath/behind the radio and ashtray underneath this trim piece. This does not require any tools (on most models) since the piece just pops up. Then, simply unplug ALL of the wiring harnesses that plug into the ECU (it is a gray metal box with a yellow plastic connector on it) and leave it unplugged for a few minutes. Then, simply plug them back in.
Mazda 626 frm 1996 doesn't have O2 sensors, have you ECU/PCM inspected, it might have a minor damage.
in the centre console underneath the stereo
No, it will take care of itself.
How can you reset an ECU on a Kia Sedona
There is no ECU reset button.
you push the reset button on the back of the ECU.
It is on because the ECU has detected a problem with the emissions system. Take it to a professional for repair of the problem. He will reset the light after the repair.It is on because the ECU has detected a problem with the emissions system. Take it to a professional for repair of the problem. He will reset the light after the repair.
A supercharger, advance the ignition timing, reset the ECU, use high octane gas.
Did you disconnect the battery for a while?
To reset the dash light indicators on a Toyota Tundra the trucks ECU will need to be reset. The simple way of resetting the ECU requires disconnecting the battery for 5 seconds. When the ECU is reset the lights will be clear.
Depend the number of the ecu and year of the car, general you can reset it, just recoded. The other option is, change the ecu and reset the ews and then you can redode the imobilizer with software machine. www.autocentralinas.com
Have the ECU scanned with an OBD2 scan tool and then repair the problem. You can then try to reset the ECU by removing the negative battery cable for 5 minutes which may or may not reset the ECU. If it does not, it will have to be reset with the scan tool.