0
1998 Polaris Explorer It runs fine but when you put it in reverse it acts like it is going to stall out and does not seem to engage Why is this happening?
Johnssalvage
This is a safety feature that polaris has on all their vehicles. It is to ensure that you will not achieve high speed in reverse as it is very dangerous. You must find the "reverse override" button. While you are in reverse, hold down the button and you will be able to go full blast in reverse and engine will run normal in reverse.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Ford Explorer 1998?
1998 ford explorer transmission reverse won't engage, acts like it is in neutral.
Why do automatic door locks engage on 2003 Ford Explorer?
Automatic door locks engage on the 2003 Ford Explorer for safety.
Why will my Ford F-150 4x4 will not engage?
Are you in neutral ? No in reverse.
Why does reverse gear not work in barina?
You need to lift the collar on the gear stick to engage reverse gear
Your ezgo golf cart wont engage in forward or reverse?
has a full charge won't go forward or reverse
Why won't the reverse gear on my Hyundai Accent 2001 automatic transmission engage?
My 2001 hyundai accent has no reverse
F350 diesel auto does not engage from reverse to drive?
take it to the shop!
Transmission will not engage forward or reverse until car has warmed up for about 15 minutes?
The transmission may not shift or engage in forward or reverse until the car warmed up for a few reasons. Two examples of why the transmission will not engage is low or no fluid levels or a leak.
My 96 dodge carvan won't go in reverse but will do everything else?
have the reverse safety switch checked if this is not working it will stop reverse being engaged this is done so as not to engage reverse by mistake
When do you engage thrust reversers?
You should engage reverse thrust just after the nose landing gear touches the ground. You should disengage it when the co-pilot tells you to.
How do you reverse a 1994 VW Golf?
Had that many cars i can't really remember but you either have to push gearstick down then into reverse or pull gearstick knob up to engage reverse. Defo one or the other :)
How do you engage the 4wd on the ford explorer xlt?
with a Large HAMMERRRthanks for the sugested solution but I TRY THAT ALREADY AND IS NOT WORKING
