The duration taken to do a timing belt kit on a 99 Toyota Truck 3.4 liter 24 valve varies from one professional to another.
it has a timing chain. its not a honda.
A 1998 Mercury Mystique , 2.5 liter V6 has : ( 1 timing CHAIN to each cylinder head , so there are 2 timing CHAINS )
timing chain and gears were replaced correct? if the problem started immediately after that was changed then most likely the timing is off.timing chain very rarely needs to be changed. the motor or trans usually goes before that. The timing gear and chain is recommended to be replaced every (I think) 50k miles, but usually goes longer than that. I'm going on 130k miles on a 720 I bought with 170k miles already on it and I'm getting ready to put in a secondnew timing chain (plus unknown number of replacements before I bought it). Engine and trans still haven't failed yet.If the timing chain was replaced incorrectly, the valve timing can be off anywhere from a little to a lot. This would definitely affect its performance. It is a difficult thing to check without disassembling.
www.motorcraft.com shows Point Dwell as 24 - 30 / Point Gap .017 / Ignition timing see Emission Decal on a 1973 Ford truck
The older 3.0 liter V6 used in the Avalon, Solara and Camry and current 3.5 liter V6 engines used in the Avalon and other Toyotas used a timing belt. The current mileage interval for replacement is either 90,000 or 120,000 miles.
Taurus uses chains. If it is a 3.0 liter 12 valve engine, it has one chain. If it is the 3.0 DOHC 24 valve engine, it has two chains.
The 2006 Honda Pilot has a timing belt. The engine is a J35 series SOHC 24-Valve 3.5L V6 motor with cylinder deactivation (2WD models only).
The 2002-2006 Camry received the next generation 2.4L 4-cylinder engine (model 2AZ-FE), which combines decent power with excellent fuel economy. This engine does not have a timing belt, it has a chain that does not need to be replaced. The second choice is very smooth and powerful 3.0-liter 24-valve all-aluminum V6 engine. Starting from 2004, the 3.3-liter V6 DOHC VVT-i engine is available on SE V6 model. Both, the 3.0L and 3.3L V6 engines have a timing belt that must be replaced at certain interval.
The Rover v6 has 3 timing belts (cam belts) they must be changed every 90000kilometers, if the belts snap you will have to replace all 24 valves, Do not forget to replace the idler pulley as well.
it depend's if it's custom rims they will range from 15" to 24" six lugs. or stock wheel like to one's Toyota have that will work on that tundra are : Toyota sequoia rims 2001-07, Tacoma 2001-2010, 4runner 2000-2010. these have the six lug pattern.
Truck Universe - 2004 2010-10-24 was released on: USA: 24 October 2010