Was a recall for wheel sensors-abs modulator common Mounted on frame, and difficult to change due to brake line removal. read ecm- get codes.
Check fuse, check bulbs, check brake light switch, in that order.
. your question about the brake light. the brake light shown not light up went you press on the brake pedal. if it light up is went you have a brake problem. good look
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
No, it is a brake light.
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
The brake light switch is on a bracket just above the brake pedal.
You can access the middle brake light from the inside of your 2000 Dodge Neon cargo compartment. Remove the brake light wiring harness. Remove the brake light retaining bolts. Reverse the process to install the new brake light.
Sometime the brake shoes will rust or freeze to the drum. TAke it to a garage.
The left brake light works the right brake light doesn't and the bulbs is good
The brake light switch is located under the dash. It is connected to the upper arm on the Brake pedal
how to replace the brake light switch at the pedal of a 2001 ford zx2
You may have to find ashop with an ABS Scanner, I don't think auto zone is equipped for this There is a problem with the abs system. Take the truck to auto zone and have them scann for a code..