answersLogoWhite

0


Best Answer

REPLACE THE MOTOR

But first make sure the nut attaching the wiper cam to the motor is not loose or has slipped. When the wipers were turned off on my 2000 LS1 they stopped at 12:00. When I turned them on they went first to 9:00 then to 2:00. I was going to replace the motor but noticed the motor always runs one way and the wipers reverse by a cam. The cam was out of sync with the motor because the nut on the motor shaft had allowed everything to slip.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 2000 Saturn LS with the windshield wiper motor out of sync How do you fix this?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the wiper motor on a 2000 Jeep Wrangler?

how to change the windshield wiper motor in a 2000 jeep wrangler


Where is the windshield wiper motor reset switch on 2000 ls1 Saturn?

There is no switch. If the wipers park in the middle or at the top of the winshield you need to replace the motor. the fault is in the logic


Where is the windshield wiper control module for a 2000 Malibu?

in the front side of the wiper motor


Where is windshield wiper control module for 2000 Saturn LS1?

That depends on what you're calling the "control module". There is a switch that controls where the wiper blades "park". It's inside the wiper motor assembly. In fact, most of the controls, except the switch on the steering column, are inside the wiper motor.


Where are the windshield wiper relays for a 2000 Nissan quest?

Where is the wiper relay located on a nissan quest 2000


Why does my 2000 Ford Ranger windshield wiper keep coming on?

When the windshield wiper on a 2000 Ford Ranger comes on by itself this can signal a damaged windshield wiper switch. Changing these switches out often corrects this problem.


Where is the fuel filter located in a 2000 Nissan Altima GXE?

It's in the engine compartment, in the rear center, up by the windshield, right below the windshield wiper motor.


Where is the widshield wiper fuse for a 2000 Nissan sentra?

The 2000 Nissan windshield wiper fuse is located in the fuse box. The windshield wiper fuse will be in the second column, third from the top.


Where is the wiper relay in a 2000 Chevy Malibu?

The 2000 Chevrolet Malibu windshield wiper relay switch is located on the firewall in the engine compartment. The windshield wiper relay switch will be on the drivers side of the firewall.


How do you change a wiper motor in a 2000 ford expedition?

Windshield Wiper Motor Removal & Installation Front 1. Turn the ignition switch to the ON position. Turn the ignition switch ON until the wiper blades are straight up, then turn the ignition switch OFF. 2. Disconnect the negative battery cable. 3. Remove the right-hand and left-hand windshield wiper arm and blade assemblies. 4. Remove the cowl top vent panels. 5. Detach the electrical hardness connector at the windshield wiper motor assembly. 6. Remove 3 wiper motor (module assembly) retaining bolts and remove the module assembly from the vehicle. 7. Remove the wiper linkage retaining bolt and remove the linkage from the wiper motor. 8. Remove 3 retaining nuts and remove the windshield wiper motor. To install; 9. Place the windshield wiper motor in position and install 3 retaining nuts. Tighten to 10-12 ft. lbs. (12-17 Nm). 10. Connect the wiper linkage to the windshield wiper motor and install the retaining bolt. Tighten the bolts to 14 ft. lbs. (20 Nm). 11. Place the wiper motor (module assembly) in position and install 3 retaining bolts. Tighten the bolts to 6 ft. lbs. (9Nm). 12. Install the electrical hardness connector to the windshield wiper motor. 13. Connect the negative battery cable. 14. Allow the windshield wiper motor to cycle several times while checking for proper wiper motor operation. 15. Turn the windshield wiper motor to the OFFposition to park the wiper motor in the park position. 16. Install the cowl top vent panels. 17. Install the wiper arm and blade assemblies. Install the retaining nuts and tighten to 22-29 ft. lbs. (30-40 Nm). 18. Connect the negative battery cable. Check the windshield wiper motor for proper operation and the wiper arms for adjustm


Where is the wiper motor on a 2000 grand prix?

Look around the center lower end of the windshield May have toi remove plastic cover


How do you remove the windshield wiper arm from a 2000 Malibu?

Break it