did you also replace the regulator? sometimes its the regulator that goes bad and not the motor.
It could be that the window motor has stopped working.
Remove doop panel, remove dust cover, remove two nuts holding window, unbolt guide post, unbolt motor, swing assembly thru openning
If the window won't go up from only one switch it is most likely that switch. If it won't go up from the driver controls or the control on that window's door, then you probably have a problem with the window motor.
It is inside the door, bolts to the regulator(the linkage that moves the glass up and down).
It is located on the passenger side of the motor after the catalytic converter. The cat is at the end of the exhaust manifold, so the connector is accessible at the motor, the sensor is accessible from underneath the car.
The front passenger window will not go down on a 93 Jeep Grand Cherokee if the motor or switch has failed. This is common when water gets inside the motor.
Yes
Your car dont like you
the wheels
Begin by removing the 1994 Chevy passenger side door panel. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
There is only one fuse for all power windows. If only the passenger side window does not work, the problem is either with the passenger window switch or the motor on that window.
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
It is bolted under dash on passenger side.
window motor
The switch could be bad at the passenger seat. The switch could be bad at the passenger seat.
Get a wire tester and start at the window motor. If it has electricity going to the motor, then the motor is burned out. No electricity, follow the wire to the switch (and so on).
the fastest way t o rule out any relays is to get at the window motor and give it a tap with a small hammer. If the motor works after that then the problem is with the window motor. the window motor should then be replaced!!!!