0
If necessary, turn the ignition switch ON and the wipers ON then OFF to bring them to the park position. Hold the wiper arm against the torque and loosen the nut which attaches the arm to the linkage shaft with a socketwrench ,remove the nut. Remove the arm and line it up with the lower end of the windshield then put it on the spines till they engage Install the nut. Then do the other wiper the same. Test to see they are working ok. Good Luck
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you adjust wipers to stop in the down position on a lumina van?
first remove wiper arms from vehicle next with ignition on, turn wipers on then off. the wiper motor will stop at the down position. replace wiper arms onto shaft ,in the correct down position where you want them. now with ignition on, try wipers again,to check if in the stop position you want them.
Your 2001 grand prix gt wipers stop in the upright position when turned off what might be the cause remedy?
The "park" switch inside the wiper motor assembly has failed.
Your 2003 Saturn windshield wipers do not stop in their normal park position they stop in the middle Is there anything you can do to fix this?
the module is bad on the wipper motor you might have to get the whole moter assy.
Why would the wipers on a 1996 Mercury Grand Marquis sometime stop in the up position and other times stop in the correct position?
wiper motor bout worn out. my 1998 merc does the same. replace ya wiper motor.
The wipers on my dodge ram operate fine but when i shut them off the stop half way up the windshield how do you reset them to get them to stop in the down position again?
bad parking relay in motor
How do you repair non-stopping winshield wipers on a 1997 Chevy Lumina?
I would suspect the wiper switch is defective. Replace it. Salvage yard is a good source for this part. In the interim, pull the fuse to stop the wipers when they are in the down position.
What causes the windshield wipers delay option not to work AND the wipers to stop in place when you turn the switch to the off position?
you will need to replace the wiper motor. there is a SET OF CONTACTS IN THE ASSEMBLY THAT STAYS TOGETHER TIL IN THE STORE POSITION[BOTTOM OF WINDSHIELD]. THIS IS EITHER BROKEN OR BURNT OFF, THUS DISABLING BOTH ACTIONS
What would make the front wipers stop working on a vauxhall corsa 2001?
I had this problem, get a second hand motor off ebay, it seems to be the problem with these cars
What causes windshield wipers to stop working?
Windshield wipers are an important safety feature on cars. They stop working when their motor goes out, or when the blade is too worn out.
98 Pontiac trans sports wipers wil not return home when put in off position?
There is a way to reset the "breakaway swicth" on newer GM wiper motors Go to a qualified GM dealer mechanic and pay. Then stop trying to wipe ice, froxen wipers, and too much snow with your wipers. Use a brush first!
Why 2001 Chrysler sebring dies at stop stop signs?
Could be the "Torque Converter Lock-up" Solenoid sticking in the lock position.
How do you change 2006 range rover rear wipers?
1. Turn on the rear windshield wipers. 2. Stop the wiper manually as it crosses the center of the window. 3. Lift the wiper blade up on the hinge as you would a front blade (this should de-activate the wiper mechanism and stop movement). 4. Change wiper blade. 5. Return blade to original position in which it was stopped. 6. Turn the wipers off then on.
