Want this question answered?
The driver door does not unlock the power locks for a few reasons. This motor could be burned out or the wires could not be attached correctly.
I think you have to push the 'unlock' button twice in order to unlock the doors.
Key?
replace master switch for door locks
Umm, there are still manual locks. Take your finger and push the lock over and unlock the door. Good Luck!!!!
Your 1998 F150 has 3 relays for your power door locks : an all unlock relay / a driver unlock relay / and an ALL LOCK RELAY I'm guessing that the ALL LOCK RELAY has failed I'm sorry but I haven't found the location of the power lock/unlock relays on your F150 yet ( does anyone know the location of the power door lock / unlock relays on a 1998 F150 ? )
There is no way to do this. There are child-proof locks on the sliding doors.
the door lock actuator is bad. it is located in the drivers door panel
It should lock and unlock with the power door locks. If it is stuck in the locked position, there is a lever in the trunk on the driver's side behind the carpet that will unlock it.
you need to reconnect the battery
2005 yukon BACK DOOR CATCH LOCK
Try This: Press and hold the drivers side power UNLOCK button. Insert key into the ignition, Turn it ON, OFF. Repeat this step twice. At this point the power door locks should cycle to indicate the vehicle is in program mode, ready to accept programming. Press and hold the LOCK and UNLOCK buttons on the transmitter. The power door locks should cycle to indicate successful programming. Turn the ignition ON to exit program mode. I tried this on my 2002 Trailblazer, this did not work