0
Dude! Just wiggle the shifter!
What is happening, is the little locking pawl in the transmission's starting to wear out. (The same thing happens on non-Saab cars, but on them you have to turn the steering wheel.) To unstick the key on a Saab, hold the key in one hand and the shifter in the other. Turn the key to the right and wiggle the shifter. When you get it just right, the key will turn.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Ignition switch will not turn Replace?
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
How do you hot wire a Saab?
Get a hot key that looks like a wire, insert into ignition and turn
How do you remove the ignition switch on a 2006 kawasaki ninja 650?
remove the front cover, disconnect the turn signals wires and the two nuts that whole the gages, then down under the ignition switch and remove the two Allen screws and disconnect the wiring. install your new one ignition switch in reverse to the instructions.
Why won't my ignition switch turn back into lock position after changing the ignition switch?
Ur life suck that why
Your grand am ignition wont turn off?
change ignition switch and/or tumbler
Do you have to turn on the switch to reset the tire pressure light?
Yes, the ignition switch must be in the ignition position -not- the accessory position.
How do you reset oil maintenance required on a Toyota Avensis?
Set the multi-information display to TRIP A. Turn the ignition switch off. Press and hold the ODO / TRIP switch, and turn the ignition switch on (IG). After turning the ignition switch on (IG), keep holding the switch for at least 5 seconds.
My 1995 F-250 will not turn off when I turn the ignition key off what could be the problem?
Defective ignition switch.
99 Jeep Cherokee Laredo stay running after turn off the ignition switch?
99 jeep Cherokee Laredo stay running after turn off the ignition switch?
The ignition switch will not turn at all What do you do?
Are you using an original key, or a replacement that has the proper security computer chip located in the fat plastic part of the key? If not, the car's security system will keep the ignition locked and will not allow you to turn the ignition switch. ALSO: some earlier models of Focus had ignition switches that were a problem. If you ARE using the correct key and can't turn the switch to start the car anymore, the ignition switch may have to be replaced.
How to reset an oil change light on a Jeep Patriot 2012?
1. Turn the ignition switch to the ON position. Do notstart the engine.2. Fully depress the accelerator pedal, slowly, three timeswithin 10 seconds.3. Turn the ignition switch to the OFF/LOCK position.1. Turn the ignition switch to the ON position. Do notstart the engine.2. Fully depress the accelerator pedal, slowly, three timeswithin 10 seconds.3. Turn the ignition switch to the OFF/LOCK position.
Why can you turn your ignition on and crank but when you turn the ignition off the ignition lights stay on?
Could be either a bad ignition switch or a bad voltage regulator (not opening circuit on shut-down)
