0
2008 Malibu codes p0010 p0011 what needs replaced camshaft sensor or crank sensor?
Wiki User
∙ 12y ago
Neither on the p0010 the intake cam accuator circuit is at fault. Ohm accuator 15-35 ohms intake on top valve cover
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What could be the problem if you get codes that say intermitted signal lost at camshaft sensor when you replaced the distribtor with a new camshaft?
Camshaft sensor interrupter will send that code.
Where is the camshaft position sensor on a 1999 Saturn sl1?
if there is no camshaft position sensor then why am i getting codes for it and how do i eliminate those codes?
Find camshaft position sensor on a 3.3 Nissan engine?
The camshaft position sensor is an integral part of the distributor. If codes and tests indicate that it is faulty, the distributor must be replaced. Last I looked a cheap one was $1,500.
How do you fix a DTC p0340 on a Ford Windstar?
Here's the technical description of the p0340-344 diagnostic trouble codes: P0340 Camshaft Position Sensor Circuit Malfunction P0341 Camshaft Position Sensor Circuit Performance P0342 Camshaft Position Sensor Circuit Low Input P0343 Camshaft Position Sensor Circuit High Input P0344 Camshaft Position Sensor Circuit Intermittent Obviously, the camshaft position sensor (CPS) is the probable source of the problem. See "Related Questions" below for more about the CPS
DTC codes P0340 for 1996 dodge neon?
Trouble code P0340 means: Camshaft Position Sensor A Circuit (Bank 1 or single sensor)
Does a 98 expedition Oxygen sensor need codes when replaced?
Just reset your computer after replacing the O2 sensor.
Why would a 1999 Chevy Tahoe continue to put out crank sensor and map sensor codes after both have been replaced?
You need to clear the codes with a engine scanner.
98 Hyundai Elantra that is running rough you are getting check engine codes that say there is a problem with the camshaft position and code that say their are random misfires Any ideas?
A bad camshaft position sensor will cause a engine to run very rough or not run at all. Replacing the camshaft sensor is very complicated.
How do you know which sensors need replacing on a 2000 Malibu?
snac ecm for codes then using code data you can determine which sensor kbutlrtech@yahoo.com
How do you clear ABS codes on a 98 Malibu I fixed problem and light still comes on I unplugged battery and light is still on how do you get it to go out?
My 1998 Malibu had the same problem. The reason that it is on is because your brake sensor is located in your wheel bearing, and most likely your wheel bearing is worn out. I replaced both front wheel bearings and the ABS light is no longer on.
Malibu abs and brake light on?
Most likely wheel speed sensor problem - either broken wire or a problem with the sensor/hub. To find out which one, you need to read the ABS codes.
What does P0340 engine codes on a 2001 dodge stratus indicate?
P0340 Camshaft position sensor circuit P0340 (M) No Cam Signal At PCM No fuel sync.
