0
If the engine is running smoothly befor this, then read on...
This is a very common problem. You have a faulty TCC solenoid. I have replaced this sensor with very simple tools (a 10 mm socket, a rachet, a gasket scraper, a T15 or T20 Torx driver, and replacement parts). It took me about 1 hour to complete having never done this job befor. The following link will tell you how to replace the sensor if you have a 125C tranny (3 speed). Althou the car pictured is a fiero, the same procedure applies. http://www.kichline.com/chuck/fiero/TCC.htm Good luck!!
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Why won't my 1985 Pontiac 6000 start?
have a pontiac 6000 2.5 motor and it wont stay running
Where is the ignition module on a 1985 Pontiac 6000?
On the distributor.
Where is the oil filter on a 1990 Pontiac 6000?
The oil filter on a 1990 Pontiac 6000 is located on the driver's side of the engine compartment. It is on the side of the motor all the way to the rear, near the firewall.
What is the gap on the spark plugs for a 1991 Pontiac 6000 le?
.060"
Where is the fuel pump located on a 1985 Pontiac 6000?
Fuel tank
Will the springs and struts from a 1989 Pontiac 6000 le wagon fit onto a 1989 Pontiac 6000 le sedan?
You could call your local auto parts store and they should know the answer to that one
Where can one find reviews for the Pontiac 6000 car?
There appears to be a large amount of information available for the Pontiac 6000 car. If one is wanting to view reviews these can be found on the Edmunds site as well as on Car Guru.
Where can you find a wiring diagram for a 1985 Pontiac 6000?
Wiring diagram of what component?
Diagram of Pontiac 6000 motor?
2.5L 4cyl base. Iron Duke
Where is the pepcock located on a 1990 Pontiac 6000 v6?
Should be at the bottom or rear of radiator
Weight of 87 Pontiac 6000 se?
The weight of the Pontiac 6000 SE is recorded as being 3,021 pounds. This weight can be altered by aftermarket products which are installed on the vehicle or parts which may have been taken off of the vehicle since being manufactured.
Why does my Pontiac 6000 have a high idle?
A sticking choke or vacuum leak are two common causes.
