0
91 firebird making scraping sound when turning left just replaced stabilizer bar still scraping?
Wiki User
∙ 17y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
When turning right you hear a clunk sound?
the stabilizer bars on the rear end usally the bushing s wear out
On a 87 firebird when only accelerating from a stop and turning right a chirp is heard calipers-rotors-pads-wheel bearings all ball joints and u-joints replaced where could this chirp be coming from?
It could be one of the bushings or seals in your steering box making the noise or it could also be as simple as an old or stretched belt under the hood. Have it checked and replaced.
What sound would a faulty wheel bearing make?
scraping sweeking grinding clicking sounds like something is grinding will be most apparent when turning
Squeeking noise from my rear left tire when turning?
Some 2001 and 2002 Sonata, XG300 and XG350 vehicles may experience a knocking or squawking noise from the rear suspension while driving the vehicle over rough road surfaces at low speeds. This noise may originate from the rear stabilizer bar and bushing rubbing together. This bulletin provides a procedure to correct this condition.The problem is the rear stabalizer bushing. The new design part number is 55577-38600Lift up the vehicle.Remove the rear stabilizer bracket mounting bolt.Remove the stabilizer bracket from the stabilizer bushing.Remove the stabilizer bushing from the stabilizer bar.Install the new stabilizer bushing after checking the yellow mark.Align the stabilizer-bushing end with the white mark on the stabilizer bar.Install the stabilizer bracket on the bushing and tighten the bracket mounting bolt. Tightening torque: 35-45 Nm (350-450 kg.cm, 26-33 lb.ft)Replace the stabilizer bar bushing on the other side.Lower the vehicle.
How do you get the head light capsules out of a 1996 Monte Carlo?
headlight must be replaced as an assembly bulb can be replaced by turning and pulling
How do you replace the stabilizer - sway bar links on a Ford Windstar?
Stabilizer bar links come in a variety of bolt 'styles'.The trick is to determine how to keep the bolt / stud from turning while removing the nut.The head of the bolts on the factory links I replaced were held in place with a small socket while the nut was loosened & removed with a box wrench.Another style of bolt on an after-market link had a spot on the backside where a wrench could hold the bolt from turning while using a socket on the frontside nut.With both nuts removed, there is small amount of tension still on the link. Lift up on the stabilizer bar, may even require a tire iron to leverage the bar upwards to easily release the link for removal.Need to say it out loud: remove the wheels for this repair job.
Chevy Trailblazer rocks when turning a corner?
sounds like your front struts need to be replaced
Is timing chain bad when theres slake turning counterclockwise?
A loose timing chain should be replaced.
Volvo S60 steering noise when turning left only?
Not sure if your having the same problem, but I bought a 2005 Volvo S60 2.5T from a dealer a few days ago and while test driving I heard a scraping noise when turning left. They said they would look into it and fix it. Today they told me they have 'replaced the front bump stops' which was making the noise... Check the Steering Fluid level!! My cap was not closing properly, that was why it lost fluid so I cleaned the cap and refilled steering fluid... Works perfectly fine.
Cooling fan is turning slow?
If the cooling fan is turning slow on a vehicle then the motor is dying. The fans should be replaced in order to avoid an overheating issues that can arise in the engine.
What needs to be replaced if your 1999 Dodge Intrepid is turning over but not starting?
Check to see if it is getting spark and fuel
Why would a 96 silverado not start after turning it off?
the battery my have a bad cell, or the starter may need to be replaced
