0
91 prelude has a slot and a diagram of a key on the left side next to the gear lever what is this for?
Wiki User
∙ 17y ago
Shift lock override. You have to press the brake to shift out of park and this won't work if the car's off. If the car won't start and you have to put it in neutral, etc, putting your/a key in the slot should release the lock.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you downshift a road king?
Drop the revs, squeeze the left handlebar lever, toe the front gear shifter down,release the lever. Brake, if necessary, while the left lever is released.
How do you change into or out of 4 wheel drive in a 98 Toyota 4Runner?
Press the button on the left side of the transfer case selector lever. It's the lever on the console next to the gear shift lever.
How do you down shift gears in a stick shift?
The gear stick has a diagram of where to move the stick to engage a certain gear. For example, if Gear 1 is in the top left corner, you must move the stick to the fair left, then forwards to engage first gear. Oh, and you have to push down the clutch each time you change gear.
A manual transmission diagram for a 95 ford escort lx?
I think you mean the shifting pattern? 1st gear- far left and up 2nd gear- far left and down 3rd gear- middle and up 4th gear- middle and down 5th gear- far right and up reverse gear- far right and down.
How do you put a 1994 jetta in reverse?
Push down on the top of the gear shift lever and push it up towards the left side of first. It is not below fifth gear as you would expect.
240 Volvo will not shift out of park?
there is a little lever you have to switch to the left. It is inside the compartment where the on the bottom where the gear shifter knob comes out.
Where do you put hydraulic fluid in a Massey Ferguson 290?
To the left of the gear shift lever, large plug on top of transmission. Fill here,
What side is the stick shift on in European cars?
It's still in the middle of the car, surprisingly, even European people prefer to not have to climb over the gear lever to get into the car. Irrespective of what side the steering wheel is, the gear lever is in the centre. On 99% of cars, first gear would be top right of the shift gate, with 5th gear top left, also irrespective of which side the steering wheel is.
How do you drive a manual transmission pocket bike?
There is a Left Hand Lever on the handlebars whick you can pull. That pulls on the clutch which allows you to change gears by kicking up a small lever a little bit forward on the left foot peg. To start off, you hold down the clutch lever, kick up the foot peg lever to 1st gear, slowly give it a little gas by twisted the throttle just a little bit, and then slowsly let go of the clutch hand lever. While riding, when you need to change gears, just hold down the hand lever, kick up to the next gear, and then you can let go of the hand lever. Hope this helps.
How do you adjust the gear shift on a 2000 Matiz se R H Steer you have to push the lever very far left to get it into 2nd?
You cannot you will need to replace the gear shift cables (there are two) because they are stretched. You can check under the lever inside the car to see if the linkage has some-how become loose.
How do you shift into second gear on a motorbike?
Almost all motorcycles are manual, and have a gear lever (not like a car, but a foot-operated lever) typically on the left hand side, in front of the left footrest, so that it can be operated by the left foot (some older British bikes have the gear lever on the right hand side). The order of gears, from the bottom, is 1-N-2-3-4-5-6 (some motorcycles may have 5 gears or less, but the order is still the same). For example, if you are in first gear, to change up to second you will throttle off and simultaneously pull in the clutch (left hand lever), then shift the lever up using the top of your boot (it can get stuck in neutral when you are starting out), and then slip the clutch and and apply throttle again. Changing down from third involves pulling the clutch in and throttling off again, and then pushing down on the lever with the sole of your boot. It is good practice to also "blip" the throttle when you are changing down and the clutch is in, so that when the gears re-mesh they are in-sync and the change occurs more smoothly - this is also better for your motorbike.
How do you use gears on a klr 250?
press shift lever near the left foot peg all the way down for first gear, one up is neutral, then from there up it's 1-6 gear. remember to use the clutch......
