Sounds like an airlock. You could try bleeding the brakes the old fashioned way but with the engine running so servo/power brake pressure shifts the airlock.
There is no procedure. The only components that need to be bled (depending on work performed) are the master cylinder, wheel cylinders and calipers.
leaky wheel cylinders or calipers
Usually not to prevent this always flush the system with new fluid when replacing brake calipers or wheel cylinders.
The calipers or wheel cylinders are bad.
The lines run from the master cylinder to the calipers and wheel cylinders.
My guess would be that you might have a bad brake hose to one of the front calipers.
Brake system usually has the following components: 1) brake pedal 2) brake fluid tank 3) brake system hoses 4) calipers 5) rotors 6) pads p.s. If it's a drum brake system - brake drums replace calipers and rotors.
if your car has rear drum type brakes you pull off the rear drums the cylinder is at the top between the brake shoes it will also have a brake line to it on the outside of the backing plate if you have 4 wheel disc brakes you have no wheel cylinders you have 4 calipers
The same way you bleed the brakes on any other Dot 3 or Dot 4 brake system vehicle. at the bleeder screws on the cylinders and or calipers
Check the proportionating valve.
Depends on which part of the braking system you are talking about.Pads?Remove wheels,Unbolt the calipers and hang them up.Remove old pads,Clean the caliper bracket, Install the new caliper hardware,Install new pads,Loosen master cylinder cap, Push the caliper pistons back flush,Tighten master cylinder cap,Pump up the brake with the brake pedal.Lots of components in a braking system, that is just the pads,, some still have shoes on the rear which is a series of clips and springs and varies from car to car.Then you have,Master cylinders,Brake boosters,Automatic braking systems,Diverter valves,Brake lines,Electric & Hydraulic Calipers and Wheel cylinders,bleeding,Pads & Rotors,Emergency cables & Motor's,
Slide calipers was invented by the French mathematician Pierre Vernier.It was known as Vernier calipers.