Camsaft Carrier cover bolts should be torqued to 72 Inch Pounds. That is for both the OHC and OHV engine. I looked this up in the manual to double check.
No. There would be a gasket between the head and the block, though.
Between the head and the engine block. This is a BIG job and I sugest taking it to the garage.
Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
Ohhh, that sounds bad. You probably have a blown seal or gasket. Get it fixed ASAP, that's dangerous.
It MAY help with the overheating problem....but you really need to find out why it's overheating. Blown head gasket, stuck thermostat, bad water pump, fan not coming on, etc.
Why change the engine ? A head gasket replacement with a head skim should cure this problem & would be a lot cheaper than a engine change best wishes
Hey Brad==This is an involved procedure. Get a manual on your car from the parts store and it will have pictures and everything. GoodluckJoe Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
how many hours to remove oil pan gasket 1995 Pontiac
i think your looking for a tourque wrench you can adjust how many ft /lb
Replace the gasket with a new one.
You don't
many possibilities; low coolant, bad thermostat, radiator fan does not work, bad relays/fuses, leakage in coolant system, stopped up coolant system, bad radiator cap, blown head gasket.