answersLogoWhite

0


Best Answer

YOU MAY WANT TO CHECK THE MASS AIR FLOW CENSOR. IT MAY NEED TO BE CLEANED OR REPLACED. ALSO MAKE SURE YOUR AIR FILTER IS CLEAN. if you really want to see what it is open the hood and have someone start it. Find the mass air flow sensor and as it is running tap lightly on it. If it straightens it out that is the problem if not i say go to the iac valve and replace it. That was a common problem with probes. The iac is called an idle air control valve and is usually around 60 to 80 dollars at autozone. ===================== The pins on the connector for the mass air flow sensor can become lax over time as well, causing the engine to not receive proper signals from the MAF. Take off the connector and push the metal connectors down so they apply pressure to the other side of the connection once it is plugged in again. Just something free to try first before buying parts. Also consider pulling the codes from the engine by jumping some test connectors in the engine compartment. Do some searching on the net, and you should be able to find out exactly how and what codes mean what. Check the main air intake hose as well, on the older model Probes at least, the hoses crack, and when gas is applied, the engine will move slightly, opening up the crack in the hose, and causing a massive vacuum leak. -Shaun

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 94 Ford Probe stalls at idle If started and throttle is applied it continues to run When driving and not applying pressure it stalls with and wo the clutch Fuel cutout light and check engine light?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When applying the emergency bandage to the head what is done?

pressure is applied to the site


What techniques is essentially pressure applied to trigger points and spams?

Ischemic pressure is the answer to this question. This technique is performed by applying direct static pressure to the affected area to help disperse the congestion in the tissues that is causing the pain.


What is done after a biopsy?

After the biopsy tissue is removed, bleeding may be controlled by applying pressure or by burning with electricity or chemicals. Antibiotics often are applied to the wound to prevent infection.


How do you stop bleeding from a cut?

For minor wounds the best method is direct pressure. This can be applied by simply pressing a cloth to the wound, or by applying a tight (but not too tight) bandage.


What are the basic law that are important in applying in fluid power and what are its significance explain?

Pascal Law is the basic law that is important fro applying fluid power.A hydrostatic principle that states when pressure is applied to a contained fluid, the force is transmitted equally in all directions.


If pressure is applied for long enough coal can become this.?

If pressure is applied for long enough coal can become this


Will applying pressure to your jaw bone make your jaw smaller?

How come your jaw become small when pressure is applied? No,it do not make your jaw bone smaller.The high pressure may make your muscles contract and make them stiff leading to less jaw movement.So you might get a feeling of smaller jaw.


What valves are anti-compounding valves?

Anti compounding valves are found in an air brake system on large commercial vehicles. These valves help to balance the pressure applied to the slack adjuster by simultaneously applying air to the spring brake relay when the service brake is pushed. The air is applied to the parking brake chamber as air pressure is applied to the service brake chamber thus releasing the parking brake the same amount that the service brake is applied thus "Balancing" the pressure in the brake chamber. This prevents excessive pressure from being applied to the service side and subsequently to the rod and slack adjuster. Thomas Moysey- owner A.B. CDL Training Center Waterford, CT


How can statistics be applied in payroll?

Statistics are applied to payroll in many different ways. The determination of the unemployment rate is found by applying payroll statistics. Without applying statistics to payroll the unemployment rate would not be found.


What is 2002 Trouble Code PO402 Nissan Frontier Pick UP?

That code is for the EGRC-BPT valve. This valve monitors exhaust pressure to activate the diaphram, controlling throttle body vacuum applied to the EGR valvel.


When the force applied on an object is doubled how does the pressure applied on an object change?

It will be double, if the area is unchanged. pressure=Force/area


What happens when pressure greater than atmospheric pressure is applied to pure water or a solution?

If a pressure greater than atmospheric pressure is applied to a solution or pure water, its water potential increases