Inspect the ground wire for the pump assembly. It may be loose, broken or rusty.
Under the vehicle, in the exhaust flow, before the muffler.
PO402 code, your EGR flow is excessive. Replace it.
Idle speed is set by the engine control computer, if yours is too low it has to be caused by an outside source, check for air flow, air flow sensors, throttle position sensors, or a dirty throttle body.
The mass airflow sensor is installed in the air intake duct If you look at the air filter box it is just to the left on the arm of the box
Going in the direction of flow
Going in the direction of flow
A: Power do not flow but rather is the results of electrons flow
IT IS FLUID MECHANICS. As water flow from a dam through channel scoops which are tied to a rotor are installed into the water streams converting the flow into motion that convert that motion into power by a generator
Your air box is most likely heating up all the air that is going into your engine or your air flow meter is faulty.
The dust particals sticks on the wires where from it sense the flow of air mixture.
how do you clean mass air flow sensor on a 1998 Nissan altima? To clean the mass air flow sensor , you need to get a can of CRC mass air flow cleaener frm auto zone, Kragen, Pepboys, Sensor is attached to the tube (next to airfilter). again you need to use mass air flow cleaner ( CRC ). I use this on my ford windstar and Nissan sentra 05 and 95. it runs better after cleaning the mass air flow sensor.
Current will flow as long as there is a difference of potential (a voltage) and a path for current to flow. So no power-control device is required for current flow but yes it will flow with a power control decive.