Your ABS (Antilock Brake System) is not functioning. You still have basic brakes. Depending on what year and model vehicle you have you need to have a dianostic scanner plugged into the system to read the trouble codes. The codes will help direct you to fix the problem. The light will remain on until the system is repaired. Many auto parts stores will scan your vehicle for codes for zip if you buy the parts needed to repair from them.
A malfunctioning brake light relay switch will cause your 1993 Toyota Corolla brake lights to stay on all the time. The brake light relay switch is located beneath the drivers side dashboard.
There could be several possible reasons why the brake lights stay on all the time on a 307. The most common reasons would be a bad relay or a bad switch.
Under the brake pedal is a brake light switch that when you press the pedal it hits it and makes your lights come on..sometimes when they get weak the pedal depresses them simply from the weight of the pedal and they stay on..Have a friend get inside the truck and pull UP on the brake pedal as you look at the lights..if the brake lights go off when they pull up on it..then it is that switch under the brake pedal
Check the brake light switch. It's under the dash, connected to the brake pedal. If it's adjusted wrong or faulty, it could cause the brake lights to stay on. If you can use a meter and tell that the brake light switch is ok, next test the turn signal switch. Sometimes they short out and leave the brake lights on. You'll have to pull the steering wheel to do that.
What year and model? Under what conditions? The dash lights are designed to stay on in certain models. Saab 900s from about 1987 on will have dash lights come on any time the ignition switch is in the ON position, whether or not the headlight switch is turned to ON.
check brake light fuse and brake light switch on pedal
Normally that light is an indication there is a problem with the brake system and MOST of the time that is low on brake fluid. There is a possibility (though remote) there is a problem with the switch on the emergency brake pedal.
why my jeep brake light on all time
The brake light switch is under the dashboard, attached to the brake pedal. Try the break pedal, up underneath the dash. This is usually a switch which will open with the lightest pressure on the pedal, which is why some people's brakelights are on all the time. Driving with one foot on the brake pedal means driving with your brake lights on. Which increases the reation time of the the following driver. (End of Sermon.)
There is a bushing that the brake light switch rest against when the brake pedal is not depressed. They are known to break. You can get a replacement bushing from any Honda dealer for around $5.00. Just tell them your brake lights stay on all the time and they will know what to give you.
you didnt specify year, but its time delayed electronically. Assuming they do eventually turn off, all is well. It's 1995 Cadillac Concours the interior lights, and head lights go out when I cut the car off but the dashboard lights stay on.
Brake lights are on continuously while you are driving. Every time the brake pedal is depressed.