Canada and US - Standard size breaker in home panel is 40 amps for stove. If not standard range open Discuss Question page.
A double breaker is a breaker that has 2 switches on it. One of the switches is 20 amps and the other is 30 amps.
The recommended breaker for dryers is 30 amps. If you want to do the calculation to see if a 25 amp breaker will work use the following formula. W = A x V, A = W/V. Find the wattage of the unit and divide it by 240 volts to get the amperage. If the amperage is under 25 amps then the breaker will work. If the amperage is over 25 amps then a 30 amp breaker on #10 wire will be needed.
The equation that you are looking for is I = W/E. Amps = Watts / Volts.
Add 25% so it comes to 42 amps
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
As a range is a high current device, the electrical code stipulates that it has to have its own breaker. The breaker protects the wire feeder. An electric range breaker is set to trip at 40 amps. Using a smaller wire that #8 is not allowed as their ratings are below that of the #8 wire. #10 wire rating is 30 amps, #12 wire rating is 20 amps, and #14 wire rating is 15 amps.
A double breaker is a breaker that has 2 switches on it. One of the switches is 20 amps and the other is 30 amps.
In standard construction this would require a 15 amp breaker and 14 gauge copper wire.
It depends on how many amps each TV draws. The continuous load should be 80% of teh breaker or 12 amps. If an average TV draws 2.5 amps that would be 4 TVs. Look for a rating plate on TV and just add the currents up.
KA stands for kilo-amps, or thousands of amps. Thus a 2KA breaker means it will trip when the load exceeds 2,000 amps.
Add 25% so it comes to 42 amps
To answer this question the voltage of the immersion heater is needed. I = W/E.
The equation that you are looking for is I = W/E. Amps = Watts / Volts.
The recommended breaker for dryers is 30 amps. If you want to do the calculation to see if a 25 amp breaker will work use the following formula. W = A x V, A = W/V. Find the wattage of the unit and divide it by 240 volts to get the amperage. If the amperage is under 25 amps then the breaker will work. If the amperage is over 25 amps then a 30 amp breaker on #10 wire will be needed.
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
Look on the heater and see what amps it is pulling. That will determine the wire size and breaker size. It must be on a dedicated circuit. 15 amps = AWG # 14 wire with 15 amp breaker 20 amps = AWG # 12 wire with 20 amp breaker 30 amps = AWG # 10 wire with 30 amp breaker 40 amps = AWG # 8 wire with 40 amp breaker
20 amp In North America code states a two pole 15 amp breaker will do the job.