Sometimes the computer goes through several "cycles" before it clears a code. If the Oxygen sensor and Map sensor codes don't clear within a few starting cycles it's possible that one or both were bad when you put them in. Read the codes again and see what it says.
there programmed into the computer.
The 1992 Oldsmobile Cutlass supreme has two oxygen sensors. Both oxygen sensors are located on the outside of the air cleaner housing.
Located on the exhaust manifold.
the 1984 cutlass had a computer but not to the extent of todays cars, I really don't understand your question.
To reset the computer on a 1992 Oldsmobile Cutlass Supreme, unhook the battery for about five minutes. Then reconnect the battery. If this does not work, look for the reset button on the computer and manually reset it.
Behind the kick panel on the passenger side of the car.
Stick the starter in the cutlass supreme.
Oldsmobile Cutlass Supreme was created in 1966.
Try changing the fuel filter and the map sensor.
The detent cable adjustment.
Yes there is, as long as it has the original V6 231 and the original electronic carb.
You don't really need to reset the computer. It does have base programming. However, it is recommended to take the car out and drive it about 10 miles. Some of this needs to be at highway speed. This will help it to "learn" the exact settings it needs. That should do it.