answersLogoWhite

0


Best Answer

There is a sensor on the bottom side of the air intake hose. You may have pulled the connector off. First place to check...

User Avatar

Wiki User

โˆ™ 2008-05-08 12:28:19
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: After replacing a fan clutch on a 93 Jimmy what would cause the engine to race when cold and hesitate to shift until it warms up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are the labor costs for replacing an engine in a Nissan XE 2.4L?

repost this question .. which part did you buy? what are the labor costs for replacing a fuel pump on a 94 gmc jimmy


How do you replace the thermostat located on a 1994 GMC Jimmy 4.3L high output?

It is located at the engine end of the upper rad hose. When replacing it make sure the spring goes toward the enigne.


What v8 engine can replace 2002 GMC Jimmy 6 cylinders?

The v8 engine 2002 GMC Jimmy 6 cylinders can be replaced with the GM Vortec 4200 straight-6 engine.


Who is replacing Conan O'Brien?

Jimmy Fallon will most likely replace Conon O'Brein when the time comes.


Why does the clutch on a 1988 GMC Jimmy leak fluid but will not shift into gear?

It wont shift because its leaking fluid.


How do you know if your GMC JIMMY engine is cracked?

oil leak


Where is the oil pan in 1995 gmc jimmy?

on the bottom of the engine.


Where is air conditioner clutch relay located on 95 jimmy?

Should be under the hood, mounted to the passengers side of the firewall.


Fuel system on 1987 gmc jimmy?

what is it that you need to know about it?, I have a 1989 GMC Jimmy 4.3L, if the system is the same then I can help a bit, doing some work on it at the moment, replacing the pump.


Blinking engine light on a 1996 GMC Jimmy?

A blinking engine light could mean several things. The only way to know for sure is to have the Jimmy checked out by a licensed mechanic.


Why does 92 gmc jimmy hesitate when accelerating?

plugged fuel filter, the injector unit (vortec v-6, 4.3L) could be bad, dead plug(s)...


How do you replace a fuel injector on a 1999 jimmy?

if you are not mechanical, replacing a fuel injector is a specialist job requiring special tools

People also asked