I had to take mine to the local Chevy dealer to get the code to reset the radio after the battery was changed. I was charged $40 by them to do this.
You disconnect your battery and then reconnect your battery again.
I have a relic pocket watch from fossil inc. I am replacing the batteries. I got the old ones our but cannot get the battery that goes to the inside in again. please explain if you can
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
MAYBE IT COULD BE A BAD SENSOR. IF IT IS RUNNING GOOD I WOULD JUST IGNORE IT.
no. you might have to reset the clock and radio.
What you probably need to do is to check you battery because i have a dodge 2004 also and my locks did the same thing so i just replaced my battery and the locks started working again.
it stops working until it gets changed again. but if its a hybrid then the petrol kicks in
The battery is only a storage device. The alternator replaces the electrical energy that the battery uses every time you start the engine and every time you turn on an electrical device in the car. If the alternator isn't working or isn't working properly, the battery will eventually discharge. Answer if the alternator is in fact working but you have let the battery run empty, simply getting a jump start might not allow the battery to charge sufficiently once you start driving again. you have to charge the battery up a sufficient amount or the battery will just run out again.
The same thing happened to me! one day i was cleaning the battery terminals and after hooking the battery back up it worked again!
Hi ! What is the problem ? Have you replaced an old battery ? I had a problem with my keyfob after replacing an old battery. The fob had no contact with the car. I then tried to open the left door lock manually with key and suddenly the fob was working again. Maybe there is need for some sort of datarecognition between the keyfob and the lock. Try Regards Bo L
The reason they won't open is it is a security feature. After taking battery out it cuts the power and when you put the new one and gets power again it automatically locks the doors.
Best guess, is that the unit should be run through a fuse panel not direct current all the time from the battery. Believe you probably burned out the motor because it was getting full current all the time from the battery