0
After your brother-in-law and you replaced the ac unit with a bypass pully his 97 f 150 wont start it will turn over but wont start why?
Wiki User
∙ 9y ago
Check the f150 engine on the front for any wiring that may have been pulled loose or damaged. The crank shaft sensor wires were most likely pulled loose during the bypass.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What could explain 92 Jeep Cherokee not to start - replaced starter 1 month ago - have to start w screw driver touching from grounding bolt on starter to solenoid -it occasionally starts by itself?
It is most likely the neutral safety switch needs to be replaced, which can be a little expensive. However you can bypass it and install a kill switch, the problem with this is if the vehicle is gear it will lurch forward if you start it
1995 firebird 3.4 i replaced the ignition now the car wont read the new key if i bypass the vats security will the car read the key and start?
If you bypass the VATS, it won't care about the type of key at all. It will use any type of key as long as it's correctly cut.
When did construction of the Hoover Dam Bypass start?
2004
How do you get a 1999 Olds Alero to start after replacing the ignition switch and key and bypass security code?
I don't think you can bypass them.
Every morning when you go to start your 2001 pathfinder your belt squeeks your belt was replaced just over 2 years ago Do you need to replace the belt again to stop the noise?
Your belt may be to tight, with the engine turned off push down on the belt, you should have about an inch or so slack. If there is no slack, loosen the adjustment bolt on the idler pully a couple turns, tap the adjustment pully until you get a small amount of slack re-tighten the pully. If you have a lot of slack this means your belt is to loose and this may cause the belt to squeek. If this the case, loosen the adjustment bolt on the idler pully, use a pry bar to apply pressure on the pully taking the excess slack from the belt, re-tighten the pully . If the slack in the belt seems appropriate; try this BE VERY CAREFULL!! Start the engine, with the engine running take a bar of soap hold it to each side of the belt. I've seem some old timers stop belts from squeeking with the soap trick. Good Luck
How do you start a mini moto with no pull start?
i don't think you can you will need to bye a new pull start or pull the cover of and find a piece of line that will go around the pully so you can start it
How you bypass to get it start will not start with key light keep flashing?
take a screwdriver and touch the screws of the starter solenoid together
How do you bypass park neutral position switch 99 Camry?
my car doesn:t start if i move my shifter sometimes it start
How do you bypass the anti-theft modulator and 1994 Ford Explorer xlt?
my daughter has a 1994 ford explorer and every so often it will not start we were told it's because the radio was hooked up to the anti theft devise which causes it not to start sometimes. How do we bypass this to get her truck to start?
How do you bypass or reset security system to start 1999 alero olds after replacing ignition switch and key?
You can't bypass or reset security system, bring it to the dealer.
How do you bypass the ignition security switch in a 2002 Oldsmobile alero?
Yes to bypass,Press on the brake, turn car to as then on let the carburetor fill then, put the car in neutral,then start. If the security light is flashing, the car will not start for 10 minutes. Do not try to start while light is flashing.
Will ac still work if you bypass the heater hoses on a 1998 ford expedition?
did the heater core start leaking? anyway you should have no problem with the air if you bypass the heater core.
