Car Fuses and Wiring
Headlights Tail and Brake Lights
VW Jetta

All three brakes light not working on 1999 Jetta Replaced the bulbs except the window one but still no lights Could it be a fuse If so where is the fuse box?

678

Top Answer
User Avatar
Wiki User
2005-09-18 22:04:03
2005-09-18 22:04:03

very easy my friend. you must locate a little switch in the top of the brake pedal. when you put pressure in the brake pedal the switch moving in and out when you release it, sometime need calibration of the switch try to move the base of the switch up or down and get some help to see the back of the vehicle if the light comes again, if no, remove the switch and try to dissarm it to clean inside or buy a new one. cchhheeerrrsss!!! i hope this help you.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I tried all the fuses, the parts that under the brakes I checked that. All lights come on and working except the brake lights no break lights.

User Avatar

Probably the flasher unit needs to be replaced. This is an electronic switch which usually mounts underneath the dashboard.

User Avatar

i have all my lights except my brakes lights.i have done everything i can think of. i need help

User Avatar

When the signal lights are not working on a car, there are a couple of things that could be going on. One could be that the bulb needs to be replaced. The other possibility is that the signal relay needs to be replaced.

User Avatar

In daylight, nothing more than working brakes. After sunset, also reflectors and working lights.

User Avatar

Where is the fuses for the brakes lights Buick Rivera 1970

User Avatar

If the night running lights have failed the bulbs should be checked. Find the bulb housings and remove the parts. After the bulbs are replaced check the lights.

User Avatar

Check the switch at the brake pedal, it is what makes the brakes come on, it may be malfunctioning.

User Avatar

If a car's lights are not working properly, the fuses should be replaced. The light bulbs should also be replaced if needed.

User Avatar

There should be a fuse for the brake lights. If the fuse is good always check the ground wire.

User Avatar

Out of adjustment. Adjust the mounting of the switch so the brakes lights are off until you press the brake pedal.

User Avatar

Working brake lights are important for safety reasons while driving. It is important to check all of the wiring, if the brake lights are not working and the fuses and bulbs have been checked.

User Avatar

I assume you have checked/replaced the bulbs. Take a cicuit tester and check the wire harness connections under the bumper and around the trailer connector if you have one. The problem must be at that area IF all your other lights are working as you said.

User Avatar

signal lights not working.

User Avatar

The bulb could be 'blown'. Remove the working bulb from the other light and try it in the socket of the one that isn't working.

User Avatar

2 separate circuits Check fuses Check bulbs Check stoplight switch Do tailights and dash lights work? Maybe switch

User Avatar

Possible bad switch on the brake pedal? When you push on the brake pedal, it activates a switch, that switch turns on your brake lights. If the bulbs and fuses are ok, check the switch with an ohmeter.

User Avatar

TRy changing your brakes and closing your doors while driving.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.