Headlights Tail and Brake Lights
Chevrolet
Chevy Suburban
Ford Explorer XLS

Why are your brake lights and hazard lights not working on a 99 Chevy turn signals and top brake light is working fine?

222324

Top Answer
User Avatar
Wiki User
2007-05-12 20:34:27
2007-05-12 20:34:27

turn signal switch needs replaced!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

hazards and turn signals have separate flashers. replace flasher for turn signals

User Avatar

the location of the hazard lights is on top of the steering colum.

User Avatar

The flasher for the turn signals is located near the fuse box under the dash in a 1995 Chevy 1500. The flasher for the hazard lights is right next to it.

User Avatar

Your car has 2 flasher relays. One for the turn signals and one for the hazard lights. The one for the turn signals is defective and needs replacing. It is located on the drivers side, under the dash, on the drivers side of the steering column, behind the dash lower panel, mounted at the base of the fuse panel.

User Avatar

The hazard switch itself is bad. The flasher module for the turn signal is built into it. Replace it yourself for 100 dollars(cost of part).

User Avatar

it is most likely a fuse or at worst the turn signals and stop lights work through the turnsignal switch

User Avatar

Check the fuses first. Is sounds like there is a power failure to the light system. There could also be a broken wire to the fuse box.

User Avatar

my 98 suburban did the same thing. when i changed my headlight switch that turns them off and on, they started working again.

User Avatar

where do most federal government dollars come from

User Avatar

I always start with the basics.......fuses. Then go to bulbs...... Look in your fuse panel and see if you have one marked tail lights......and check it. the brake, headlights and signals work off another circuit.

User Avatar

If the turn signals are not working properly on a 2002 Chevy Venture and the fuses seem to be alright, check for burned out bulbs in the turn signals. Also, check to make sure the turn signal flasher is working properly.

User Avatar

Yes, they are located pretty close to one another under the driver's side of the dash. They look similar, but one is used for the hazard lights and one is for the turn signals.

User Avatar

My dashpanel lights stopped working in your Chevy Monte Carlo ss 2001 what could the problem be

User Avatar

First replace your turn signal flasher as it usually only costs 3-10 dollars; the location varies- many times they are on or near the column under the dash.

User Avatar

Check all of the three bulbs try replacing with working bulbs this should resolve the issue unless you have a bad module.

User Avatar

the connection between the battery and the brake lights

User Avatar

If the vehicle is equipped with a trailer light plug, the wires for the brake lights and the turn signals have been connected together, which is common, as many trailers do not have separate lights for brakes and turn signals.

User Avatar

If turn signals are working could be a bad bulb If turn signals are not working--could be fuse flasher or problem in steering column


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.