Either weld or replace.
If you have all the front parts then yes, you should need to replace the headlights, fenders hood, and then the nose.
you would have to get the hood also, but the conversion can be done
The Camaro started using the 4L60-E in 1994, so that's what your 96 Camaro should be set up for already.
a Haynes manual would be your best reference for step-by-step removal and installation of any do-it-yourself work
check to see if your spoiler brake light is out replace it and it usually will finish the ground to the abs sensor and cruise control
how to replace oil pump on 1994 z28
That would be the 4L60E
i want to know what type of antifreeze does 1994 chevy camaro
it is 5000 rpms. (3.4 is the v6 1994 camaro.
There was no RS Camaro in 1994.
It would not be a direct bolt up since the hood and fenders are slightly different from each other
By all means, yes it will
theres a great website called shbox.com that has the routing diagram for the ac hose.
i have 20 inch rims on my 1994 camaro and every time i turn the wheel it hits
you don't, there not the same.
pull off the power steering pulley and there are 3 bolts under it and the rest are visible
Possibly loose connection or the relay is failing. Replace the fuel pump relay first.
BAD power brake booster are a vaccum leak at the booster.
The 1994 Chevy Camaro horn is located in the front of the engine compartment. The horn will be on the right hand side of the radiator.
They were the exact same wheel, so yes
That's easy because there was no Camaro SS in 1994
In 1994 there was no SS Camaro. The Z28 had a 5.7 liter V8. The base Camaro had a V6.
The speedometer on the 1994 z28 Camaro has both MPH and KPH on it. The KPH are the red numbers on the inside of the scale.
It would be best to remove the alternator and take it to an electrical shop.
You can't and will have to buy new ones or replace the instrument panel with a used one.
It would be a good race but I think the Z would win in the end.
in 1994 they still used the green antifreeze.
It will cost you approximately $90 to replace your 1994 Jeep Cherokee oil pan gasket. The oil pan gasket will cost approximately $30 and require one hour of labor.
Would really need a more detailed description of the problem, including the circumstances under which it happens.
1994 Camaro convertible v6 curb weight 3324lbs, the one you asked about v8 curb weight 3247lbs. According to Edmunds.
1993 to 2002 camaros and firebirds have the same t tops, problem is you wont be able to lock them unless you have a key made for them.
replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo 6 cylinder
Well I had an ignition coil replaced in a 1990 Oldsmobile and the coil cost approximately $50. Labor would probably cost approximatley $35.
take it to a mechanic.
no. 96 was the first for that body style.
Yes it will fit right in there.
if it is a 3.8 then it has about 220 at 5200 rpms (3.8 is the v6 1995-2002 i think) OR if it is a 3.4 it has about 175 at 5000 rpms. (3.4 is the v6 1994 camaro)
Open the rear hatch, if there is one present it would be on the right side underneath the removable upright panel.
With enough money and time you can make anything fit. But no, it will no bold in place.
I dont think your going to ever get it to fit well unless you completly reform it to fit the 76 which would probably take 500 hours and a very skilled person
Passenger's side of the transmission.
you have a bad heater core
Gm does not use inertia switches.
NO it will not. Not even close.
hi, i need to know how to replace the heater core with a/c on a 1994 gmc jimmy. a diagram would be helpful
I call a mechanic, someone who wouldn't ask the internet how to do it
No. The 4th gen rear end is 4 inches longer.
No, because the two years have two different body styles