0
Add your answer:
Earn +20 pts
Why did timing ignition fail smog on 1989 Toyota Celica?
One of the primary causes for this is a stretched timing belt. Even though the belt is a notched belt, they do stretch just enough to make the timing not conform to smog specs. I have had this happen, too, and found that a timing belt replacement solved the problem.
Is the cam belt change mileage the same for automatic and clutch change cars?
NO, The book says every 50,000 miles but i have never seen one fail until 125,000 miles.
What is a fail passive and a fail operational auto pilot system in aircrafts?
Fail-passive Automatic Landing System An automatic landing system is fail-passive if, in the event of a failure, there is no significant out-of-trim condition or deviation of flight path or attitude - but the landing is not completed automatically. NOTE: For a fail-passive automatic landing system the pilot assumes control of the aircraft after a failure. The following are typical arrangements: (1) A monitored automatic pilot in which automatic monitors will provide the necessary failure detection and protection. (2) Two automatic pilots with automatic comparison to provide the necessary failure detection and protection. Fail-operational Automatic Landing System. An automatic landing system is fail-operational if, in the event of a failure, the approach, flare and landing can be completed by the remaining part of the automatic system. NOTE: In the event of a failure, the automatic landing system will operate as a fail-passive system. The following are typical arrangements: (1) Two monitored automatic pilots, one remaining operative after a failure. (2) Three automatic pilots, two remaining operative (to permit comparison and provide necessary failure detection and protection) after a failure.
What causes an automatic transmission to fail to up-shift?
a bad radiator -automatic portion of radiator not cooling off transmission
When should you change your timing belt on a 2003 Toyota Corolla?
There is no Timing belt in corolla 2003 to 2008 model, Toyota start the timing chain for all these series that's what the Toyota dealer said.Your Toyota timing belt/timing chain plays an important role in the running of your vehicle. The Toyota timing belt/timing chain is typically tucked away behind the front cover of your engine, but just because it is out of sight does not mean it should be out of mind. Indeed, far from it, your Toyota timing belt/timing chain must be in working order for your vehicle to be operational. The Toyota timing belt/timing chain winds around the camshaft and crankshaft, and is assisted by the idler pulley/tensioner. It is responsible for seeing to it that the valves operate at the right time sequences to permit the correct amount of air and fuel into the engine, as well as allowing exhaust to escape. Clearly, if a malfunctioning Toyota timing belt/timing chain is not allowing air and fuel into the engine, your vehicle is not going to get far. The Toyota timing belt/timing chain is a part that should be changed according to the recommended maintenance schedule, whether or not it is showing any wear. That is because this is a part that can, and often does, fail without warning. While estimates may vary between individual automotive technicians, the general recommendation is to replace the Toyota timing belt/timing chain at about the 60,000-mile point. However, if your driving circumstances tend to be a bit more demanding than those of the average driver, you may want to consider replacing your Toyota timing belt/timing chain a bit sooner.
What happens when you fail the eyesight test during the driving practical test?
it is counted as an automatic fail and you will have rebook and repay for another test
How do you know if the timing belt is on right on a 97 villager?
Give more info., did previous timing belt fail?
Why No alternator belt?
The alternator must be driven by a drive belt, or your charging system will fail. Your question really makes no sense.
What are the Symptoms of a broken serpentine belt?
All the services driven by this one belt fail at the same time. Generator, pump, etc.
What will happen if alternator belt too tight?
The bearings of all the belt driven accessories will have excess strain and likely fail prematurely.
Why is Serpentine belt on Chevy silverado 1500 squeaking?
It may need adjusted. Some belts will squeal just before they break so check the belt for wear before tightening. As for the wear, one guideline is that if you see cracks across the grooved side of the belt 1/8" apart or closer, change the belt. You'll find an automatic belt tensioner on late model cars/trucks. It can be identified as a spring loaded pulley. Sometimes these weaken and fail to provide the needed tension on the belt causing it to squeak. In that case, the tensioner needs replacement.
Can you bend valves in a Chrysler cirrus when water pump and timing belt fail?
Yes
