NO. the electronics on the 97 model are differnant than the 93 model. The 93 model has an A4LD and the 97 is a 4R44E/4R55E Macs Transmissions (Houston, TX) 281-394-4951 Macstransmissions@gmail.com
I believe that begining in about 1993, the transmission came electronically controlled. At a minimum, the valve body would have to be changed. It is better to find a unit form a 1990 to 1992. 1989 and earliers had a different shift linkage. The bellhousings are different between 2.9L and 3.0L engines. The pump is part of the bellhousing, therefore some disassembly of transmission is required. DO NOT attempt this if you are not familar with transmissions!
yes you can all you need to do is change the tail shaft cover between the two transmissions
( No ) the 1997 Ford Explorer uses automatic transmissions that are ELECTRONICALLY controlled , where the 1992 model year is not ( P.S. I'm not a mechanic / technician )
I have researched this question to an extent and according to what I have found, if you have a 3.0 engine the transmission out of another ford with a 3.0 engine only will fit.
aerostar 3.0, 4.0 mustang 3.0, 4.0
Will a 1997 Aerostar transmission fit in a 2000 ford ranger?
On a 1993 Ford Aerostar : The automatic transmission modulator is on the passenger side of the transmission ( it might be behind a heat shield )
The Bands in the transmission are slipping/ the tranny is bad.
i changed a transmission over from an 88 aerostar to a 93 aerostar, the only problem i had was with the shifter . the shift cable on the 88 was a floor shift and the 93 was on the steering coloumn. all aerostars have a plate on the floor where a floor shift can be installed. i removed this plate and installed the floor shifter from the 88 into the 93 problem solved ....hope this helps
dick
WHERE DO I PUT LUCAS TRANSMISSION FIX IN A 1992 AeroSTAR
For a manual transmission: 5.6 pints. For an automatic transmission: 19 pints.