Where is the radio amplifier in a 1989 mercury couger
it doesn't go down.
read the instructions manual.
The antenna is located in the windsheild. Look for some very small wires imbeded in the glass.
In order to take the factory radio out of a 1999 Mercury Cougar you must have DIN tools. Once you make sure you have these, you can insert the tools into the screws on both sides of the stereo. After the tools are inserted, you need to push the tools to the outside of the stereo (slightly) to release the lock mechanism. After the mechanism is released, you can pull the stereo forward and out of the dash. Finally, you need to remove all the connectors and the antenna.
The radio antenna is a fine wire imbedded in the windshield. If your radio doesn't pull in any stations, but you get static then probably the cable came out of the back of the radio. If you recently got a new windshied it may have not had the antenna. You should be an antenna at an auto parts store and install it on the front fender.
There is no button for the power antenna it works by it self if you turn on the ignition and your radio is on the antenna should come up by it self, if problem doesent go away it could be that ur radio isent hooked up to the antenna (yellow wire) or your power antenna blew.
There is nothing to reset except the radio presets and the clock.
Its on the right side of the hood. It runs under the hood and through the firewall to the back of the radio
Remove the radio retaining cover from your 2000 Mercury Villager radio. Remove the radio retaining screws. The stereo will slide out. Remove the antenna cable and the wiring harness from the back of the stereo.
Radio antenna can be translated as: Funkantenne Radionantenne
cut wire between the dash and radio and fuse box.