did u ever figure it out?
There are several reasons why a 1996 Achieva engine cranks but will not fire. A few of the reasons could be a bad ignition control module, ignition coil pack, or a crankshaft position sensor.
the transmission is clogged with congellied oil
The 1996 Oldsmobile Achieva takes 19" replacement windshield wipers on both sides front.
The 1996 Mercury cooling fan relay switch is on the back of the cooling fan motor. The relay switch should be labeled as such.
is it hard to change the water pump on a 1992 Oldsmobile achieva. Yes, it is very hard to replace a water pump on an Achieva. When the pump died on my 1996 Achieva, the engine needed to be unbolted and removed to get to it. As I recall, it cost about $500. I have a 95 Olds Achieva 3.1 and the water pump was very easy to change. Mine is on the front passenger side of the engine. Very easy to get to, just be careful not to break any bolts off. lol
The 1996 Pontiac Grand Prix cooling fan sensor is located on the front of the engine. The fan sensor can be found just above the thermostat.
It is in the gas tank.
I just lost my 1996 achieva due to engine fire, GREAT CAR, it will be missed. It was the 4 cylinder 2.4L engine. 5 speed stick. I was having a misfire on cylinders 1 and 3. My ignition coils were bad. Ignition coils are found just under the engine cover above the spark plugs.
Front passenger side of engine bay in fuse box.
mine kick on around 230 temp.
The radiator is located in front the engine cooling fan and shroud, at the front of the motor. _____________chassis_________________ _____________________________________ Fire wall motor ~cooling fan~ radiator ________________________________________ chassis
Under hood, passenger side, front engine area, mounted above radiator on radiator support
Sometomes it is hard to get all of the oil out of the cooling system. However the place that replaced the engine should flush the cooling system until it is clean. Also if your car has an engine oil cooler , it could be the cooler in the radiator and not have been the engine in the first place.
The 1996 General Motors/Chevrolet K1500 4WD PU came equipped in 4 engine codes. The standard equipment 4.3L Vortec (code 'W') has a cooling system capacity of 13.2 quarts.
15 or 16.
Coolant temperature sending unit is located on the front of the engine. The cooling temperature sending unit will be on the right hand side of the engine.
should be non interference
Yes, the mounting position is the same, but the actual mounts are different. Bolt the mounts from your 1975 corvette to your 1996 LT1 engine and it should go right in. The transmission should also bolt right up to your 1996 LT1 engine.
YES BUT. YOU SHOULD USE THE 1996 CRANKSHAFT AND THE 1996 INTAKE SO YOU NEED TO DISASEMBLE BOTH ENGINE TO DO ONE
After the caliper is removed, it should slide right off. If it does not slide off because of rust or dirt. The impact of a hammer should dislodge what is holding it.
Should go in the engine end Should go in the engine end
The correct term is interference engine. No the 1996 Tacoma V6 is not an interference engine. However, you should replace the timing belt every 60,000 miles.