answersLogoWhite

0


Best Answer

Closed or faulty fuel valve, clogged or faulty inline fuel filter, improperly installed or broken fuel pump (if equipped).

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Briggs and stratton engine fuel not going to the carborator?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is Briggs Stratton going out of business?

Is the rumor true? Is Briggs Stratton going out of Business?? We were told not to by lawn mowers with the Briggs stratton motors.


Reloading 7.62x51 subsonic ammo?

I'm going to say no, that would be like putting a Briggs and Stratton in a '69 Camaro...


How do you change the pull cord on a Briggs and Stratton mower engine when it appears the housing is riveted?

I'm doing this now. i drilled through the rivets. started with an 1/8th drill bit and a little oil on top of the rivet. the problem is going to be finding replacement screws that will hold the starter cage once you have replaced the cord. some Briggs and stratton engineer needs to be taken to the wood shed.


How can I tune a Briggs and Stratton mower?

Depending on how this mower got out of tune is how you are going to know how to tune it back. It may be as simple as adjusting the mixture screw on your carburetor, or as difficult as filing the points (older engine) or replacing the diaphragms on the carburetor.


What are the difference between Briggs and Stratton crankshafts numbers 494035 and 494075?

Try going to www.briggsandstratton.com you can reference parts based on the engine model number and you can even email questions to people. This is where I go when I need to find something out for my mower.


What is the cylinder head torque setting for Briggs and Stratton Lawn tractor model 3310707-0136-E1?

Try going to their web site or you could order a manual from them.


How do you adjust valves on a Briggs and stratton engin?

The valve clearance is set by grinding the faces if there is too much clearance or grinding the tip of the stem if there is too little. If it is a OHV engine you can easily adjust the valves. Try going to the link below for a video that shows how to adjust the valves.


Is Briggs and stratton going out of business?

Absolutely not, they are the world leader in small engines in both the USA and global markets. They consistently show strong profits and manufacture an outstanding product.


How do you convert a horizontal sharft lawn mower engine into a go kart engine?

You Going to have to rotate the carborator because they dont run sideways then you will have to to take the engine apart so you can find a new way to sling around the oil.


Does Briggs stratton engine has to much compression acts like the battery is weak if the plug is out turns freely have set the valves to the best of abilities is there something else?

No, it can't have too much compression. It sounds like the battery or starter motor is going bad. Fully charge or replace the battery, then have the starter tested.


How fast does a 5 horsepower Briggs and Stratton engine go?

It really depends on what all is done to it a stock motor with nothing at all done to it will probably do 30 with the govenor set at about 3500-4000ive got one with no govenor aftermarket exaust and air filter and a shaved head that will go 50-55


Why would a Briggs and stratton vangaurd 18 hp engine die when hot but run good when cold?

it very possibly is something electrical like the coil breaking down or the stator located under the flywheel.take the flywheel off,disconnect the wire going to the stator and check to see if there is any ohms going through the wire if not it is the stator.if you have ohms and the windings all look good then it is probably the coil