There are two. One by the water pump, and one down by the pully. You have to have a puuler to get tho that one.
The 2.8 engine doesn't use a cam sensor.
Cam shaft sensor is located under the power steering pump on the block
To replace the cam sensor on a 1991 Buick Regal with a 3.1L engine, first disconnect the negative battery terminal. Locate the cam sensor, which is typically found near the front of the engine, and unplug the electrical connector. Remove the mounting bolts and carefully take out the old sensor. Install the new sensor in the same position, secure it with the bolts, reconnect the electrical connector, and finally reconnect the battery.
The cam sensor on a 99 Buick Regal is located behind the rear cam bearing cap. It monitors the rotation of the cam and relays information to the vehicle's computer.
On front cover of engine, slightly above crankshaft pulley.
your buick is ovisley not super charged with coil packs because its looking for a cam sensor
what is location of cam positioning sensor on 2005 scion xb
Under the powersteering
where is the location of 98 Kia Sportage 4x4 2.0 liter cam sensor?
Does not have a cam sensor on a 7.3L IDI this engine is not computer controlled.
check your cam shaft sensor
The cam sensor is under the front of the passenger side cylinder head