Yes it's possible. But installation can be unreliable. So better to ask about it to home experts. If you are looking for Ceramic tile for order then you can get it easily through stores like "BuilderoutletUSA"
Definitly do not do this. Out with the old in with the new.
Or only if u have to save money, and only if the tile is horriffic. Would hve to smooth tile with leveler.
Yes. The vinyl has to be specially cleaned and treated in order for the adhesive to stick. Special products and instructions are available at most home improvement stores.
Ceramic tile can be installed over any non-compressible solid, non-flexible surface, but in areas of high moisture or possible water penetration, a cementious or water impermeable backer should be used to prevent rot.
Bead blast or score the concrete first anything from a wire brush to a floor sander might work...be VERY CAREFUL with the dust though
Depends where ya live. In MIchigan Its $5 to 8 a square ft. that's just labor. Ya get what ya pay for. It also depends if its walls or floors, what prep work needs to be done.If the floor is level,ect. Some companies have a standard price for 3 walls over a tub,or backsplash's What is the cost of installing ceramic tile in Dallas Tx?
If you have never installed a ceramic tile floor before, I would highly recommend hiring a professional to do it for you. If you don't want to do that, companies that sell ceramic tiles, such as www.BuyTile.com, can probably advise you on the best way to do it yourself. For example, site's FAQ even includes advice on hiring someone to do the installation. Good luck!
That would depend on whether they are ceramic tiles or more vinyl tiles.
Only if the vinyl was previously installed over concrete, and has a positive bond. Scar the finish of the vinyl with a hand sander (course paper), and use a high strength thinset for the installation.
If it has a timber floor under and vinyl is solid to the floor and not to thick screw down 10 mm ply at 150mm centres. seal ply with pva sealer prior too tilling. If it is a concrete floor it is best to lift vinyl.
It is best to remove the vinyl tile. If it is not on cement and is on wood you can install cement backer board. Be sure to put thin set under the board. If you spend the money and time to install ceramic tile and the vinyl tile comes loose all that $ is down the drain What is the best tile cement to use and this cement tile can be installed on vinyl tile and install ceramic tile on it
If the vinyl is down tight , the answer is YES, Laminate con go over it
yes.
Yes. The vinyl has to be specially cleaned and treated in order for the adhesive to stick. Special products and instructions are available at most home improvement stores.
Ceramic. Ceramic.
It is possible, but it's not the best practice. If you can easily remove the existing vinyl, then do so. If the vinyl won't peel up, then you should consider two possibilities: Remove the vinyl along with the wood underlayment (or scrape it off if your subfloor is concrete), or install new wood underlayment on top of the existing vinyl.A third possibility is this: If the existing vinyl is securely glued to the floor, you could apply an embossing leveler (cement-based product) in a very thin skim coat over the vinyl. This seals in any stains, levels the floor, and gives the new vinyl a nice, smooth surface to lay over (or a good surface for vinyl glue to adhere to).Most flooring manufacturers will not honor the warranty on their vinyl if it is installed over existing vinyl, unless you do the embossing leveler step above.
yes, but it will slide over the years so I would not
Yes but you may want to apply a leveling compound between the two vinyls and also take care to make sure the original vinyl is well stuck otherwise they will both end up coming off the floor.
Only if the vinyl was previously installed over concrete, and has a positive bond. Scar the finish of the vinyl with a hand sander (course paper), and use a high strength thinset for the installation.