Yes,
It will tell you bank 1 or 2
then sensor 1 or 2
...Bank 1 is the exhaust pipe coming from the side of the engine with cylinder 1.
Sensor 1 is before the catalytic converter, and sensor 2 is after the catalytic converter.
With an OBDII scan
Using any quality OBDII diagnostic device or OBDII to computer conversion software should be able to tell you the Mass AirFlow sensor outputs.
Bad bearing Bad valve
The check engine light will appear. USUALLY A GOOD OBDII SCANNER WILL TELL YOU WHICH O2 SENSOR IS FAULTY EITHER BE A SPECIFIC CODE OR DIRECTLY. THE CHEAP SCAN TOOLS MAY ONLY TELL YOU THAT YOU HAVE AN "o2 FAULT"
you can contact any dodge dealer and give them the last 8 digits of your vin and the can tell you everything you have on that car.
Counter clockwise to remove.
Take It Off Amd Inspect It.
Base models had the 2.7L V6, the upper-level ES models had the 3.5L V6
I have a 2003 Dodge Ram 5.7 4x4. Can you tell me where the IAT Sensor is located ? I have a G-Force chip to install. Also can you tell me the 2 correct wires to use ?
You need a special tool available at some parts stores to rent and they can tell you how to use it.
Hey Joseph==If you are really interested in changing the engine, go to the parts store and get a manual on your car. It will tell you how. GoodluckJoe
Use an OBDII scan tool, if you don't own one go to just about any auto parts store and they'll scan it for free and tell you what the code means.