Yes! a coaxial cable can go bad. Yes! you can suddenly lose the signal from an atenna because of a bad cable. A a new coaxial cable may fix the problem as long as the damaged cable is the source of the problem. However if the signal problem is at the tap or one of the splitters in your home you will need to call your cable company to fix the problem.
Sounds like an antenna or coaxial cable problem, especially if you're still getting some AM frequencies. AM receivers can often pick up stations even with the lack of antenna input, but FM receivers are pretty unforgiving. Check that the coaxial cable is plugged properly into the back of the radio, then check, if necessary, the connection at the base of the antenna, assuming the antenna is still there. Those are the two most likely locations for coax trouble.
You will need a tv antenna and a coaxial lead in wire with connectors.
A coaxial cable has great uses in television antenna connections. TV satellite connections also use coaxial cables to connect decoders to the TV set.
Answer1998 MY (model year) Accent vehicle do not have a power antenna. Antenna mast should simply unscrew from mount.Step 1Activate the antenna switch to the up position.(turn on radio)Step 2 Using the wrench or needle-nose pliers, loosen and remove the original retaining nut on the base of the antenna mast.Step 3 Gain access to the underside of the area where the antenna is located.Step 4 Remove the bracket or brace that is below the hole and holding the antenna in place.Step 5 Remove the mast.Step 6 Find the motor that controls the antenna mast. Generally, power antennas will have a constant 12-volt lead and a ground lead. The ground lead will be grounded to the panel next to the motor.Step 7 Remove the ground lead from the panel.Step 8 Pull out the antenna coaxial cable.Step 9 Unplug the coaxial from the extension coaxial cable.Step 10 Remove the original antenna coaxial cable. Note the route the cable follows.Hope it helps
You should be able to connect the RF adapter that came with you NES into the coaxial cable port on your tv even though you probably don't use that connection anymore for your cable or satellite connection. Then all you have to do is put your tv on the antenna/cable input and tune it to channel 3.
There are two types of cable used for television radio frequency signals: 300 ohm twin lead flat cable and 75 ohm coaxial cable. The twin lead is typically used with a rabbit ears antenna and coaxial is typically used with roof top antenna or cable TV setups.For television baseband video signals coaxial cables are usually used.However for digital television baseband video signals these are not adequate and special cables (e.g. HDMI, DVI, DisplayPort) are used. These cables are typically many twisted pairs in a common shield.answer is Coaxial cable
RG-59 is the most common coaxial cable used for broadband CATV connection.
Sometimes this will happen if you are using a coaxial cable on the antenna and there is a broken connector or even a cut in the cable somewhere.
Coaxial cable, RG6u or RG 59u. The RG6u has less loss for longer cable runs.
You can buy these products,but you could also rig one your self with an old antenna and some coaxial cable.
The TV has video input in the forms of a coaxial (tv antenna/cable) and RGB inputs.
I could be wrong, but I believe you are talking about an HDMI cable. Between the antenna and the TV set use RG6 cable.