That's almost twice the voltage. The chances of frying your device is high.
No the voltage gap is too wide. If the higher voltage is used there is the possibility that the connected device might be destroyed.
No. The adaptor will overheat.
No. Usually it's a -/+ 10% difference. So, a 9v would need at least 7.2 volts or more
yes, if the other adapter is a va
No. The device requires a 9V supply capable of delivering at least 1A. You're trying to supply it with a 5V supply. Go buy the right adapter. Just because there's a physical fit, it doesn't mean the part is the correct one. If the 9V supply can supply a little more than 1A (say, 1100 / 1200 mA) then that would be acceptable. If can only supply 900 mA, it may not work correctly.
To modify the input voltage to match the desired output voltage. Say you need 5V to operate TTL technology and you only have a 9V battery. You build an SCC change it from 9V to 5V.
To modify the input voltage to match the desired output voltage. Say you need 5V to operate TTL technology and you only have a 9V battery. You build an SCC change it from 9V to 5V.
No. The windings are set for 9vdc and will not step down to 5vdc.
Yes. (For any pairing of power supply and device, as long as the voltages are a match (in your case: 9v), and the output (in amps or milliamps (A or mA) of the power supply IS EQUAL TO OR GREATER THAN the current required by the device (in your case 1300mA or higher) then you will be fine. Yes it is suitable: The OUTPUT VOLTAGE (5v, 9v, 12v, etc) of a power supply MUST BE EQUIVALENT to the required voltage of the device to which it is to be connected, whereas the output CURRENT (500mA, 1A, 1500mA, 2A... etc) offered by the power supply MUST BE AT LEAST EQUAL TO OR GREATER THAN the current required by the device to which it is to be connected. (in your case, for example, as long as the power supply is rated at 9v, you could use one that has a rating of 1300mA, 1400mA, 1500mA, 1A...and so-on, without any damage to either device)
Probably not. There are two types of adapters- regulated and non-regulated. An unregulated 9V adapter might have as much as 16 volts across its terminals when not connected, and deliver only 9V under load. Enough to fry something expecting 7.5 volts. A regulated 9V adapter is better behaved and will probably deliver 9-10 volts. Still, this may well fry your 7.5 V device. Get the right adapter.
Unfortunately no, if the device calls for 2000ma you will need a 2A (amp) power supply to adequately power it.
No, the adapter's power output has to be equal to or greater that the current draw of the device.