I am asking the same question for a 1979 Chevy C30 PU Truck & would like to see some photos or schematics. Thank you
I need the wiring diagram on a 1986 Chevy silver ado dual fuel tanks
Where can I find a diagram for running new fuel lines on a 1992 chevy pick up
when you have two tanks on your vehicle the fuel tank selector valve chooses what tank will send fuel to the engine. both tanks run into the valve
Sends power to the selector causing the door inside the unit to open and close swapping tanks.
dual tanks i imagine the tank selector located right be hind the transmission in the frame rail
Get a manual on the truck from DISCOUNTAUTOREPAIRMANUALS.COM and it may have the information you want. It will help on the next repaire also,
There usually isn't a fuel tank selector on these trucks.. either you'll have a crossover which goes from the two tanks to the engine, or you'll have separate lines going to the engine (and returns to the tanks), but fuel is drawn from both tanks simultaneously.
The traditional three port fuel selector valve is designed to allow the operator to switch between two fuel tanks, without having to switch the supply hose from one tank, to the other. Each of the two outboard, (outside) ports, go to your fuel tanks. The middle port is the outlet to your engine.
( No ) there should be a selector switch ( or valve ) to use to select which tank you want to use
Yes, 1 pump per tank.
These models have a fuel selector switch that is vacuum operated, near one of the tanks. First, check to make sure the vacuum lines are intact and connected. If so, a new selector switch must be purchased and is available from most part stores. It depends on the year of truck you have on 1985 and newer there is a electric switch and you have to pull instrument cover to get to it. If you are having trouble changing tanks it might also be the fuel pump is bad in one of the tanks.. So listen to each tank and see if you hear them run when you switch tanks
dual tanks 15gal each